Mitsubishi Heating & Cooling - Page 6 - Recent Questions, Troubleshooting & Support


brown liquid usually is rust, could be from the a/c or the heater block you would need to investigate further to determine the liquid, is there any water lose, is a/c pressure still ok, if you have not had the a/c checked in 3 years I would have it checked.

Mitsubishi... | Answered on Jul 11, 2017


Compressor is likely shorted to ground. With a multimeter you could ohm the compressor to verify. With power off remove wires at compressor. Test each leg to ground or metal or a piece of copper. Continuity would confirm a grounded compressor. Warranty, age and cost would determine next step.

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Mitsubishi Mr.... | Answered on Jul 09, 2017


Outside unit does not have a filter. You can try to pull the disconnect on the outdoor unit. Reinsert after 10 seconds, see what happens.

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Mitsubishi... | Answered on Jul 08, 2017


Sounds like you have a power issue if all 3 goes out the same time

Mitsubishi... | Answered on Jun 27, 2017


you dont have enough fall creating a water trap which breeds bacteria into a green slim ball blocking drain you need to chop more brick wood what ever the pipe drain go through so there is very good fall problem solved the pipe being blocked causes water to back up these heads can loose 4 ltrs an hr in qld not sure on other state hope i was some help
regards john
[email protected]
topnotchelectrics.com.au

Mitsubishi Mr.... | Answered on Jun 25, 2017


Sounds like the filter or coil is dirty, therefore fan amount up and hindering drainage. Vacuum drain, clean coil, change filter.

If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Mitsubishi... | Answered on Jun 20, 2017


No it will not .Gist you have to check what is preventing the compressor. Those unit have a lot of safety so first thing reset the unit and you do that by shutting the power off then turn it back on .
You then look at the compressor to serve what it's doing .If it comes on and run for a minute then shut off again that means the coil is dirty so you should wash it .If compressor does not do anything then check the control board for any blown buss fuses.
If no bad fuses are found then you need to see if system have any freon (refrigerant) .If your guages is reading 0 or reading very low it means you have a leak and that needed to be fixed before your ac could work again

Mitsubishi... | Answered on May 19, 2017

Not finding what you are looking for?
Mitsubishi Logo

1,405 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Heating & Cooling Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

NOEL
NOEL

Level 3 Expert

8549 Answers

Vernon Taylor

Level 3 Expert

7415 Answers

Are you a Mitsubishi Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...