Miller Welding Tools - Recent Questions, Troubleshooting & Support
Help code 24 ?
On this page enter your serial number and you will be able to download your manualhttp://www.millerwelds.com/service/ownersmanuals.php In the Dynasty 350 manual
On Page 76, section 7-4 it says:
Help 24 Display
Indicates a power supply to the control and
interface board PC6 failure. Possible cause
is a short in Pin A or Pin B of the remote
Unplug the remote control and see if it goes away.
TIG weding is next to brain surgery as far as CLEAN goes.
You must get your AL clean, either by 1. Clean with a NEW Stainless Steel brush or 2. by using a chemical from the welding house that is made just for that.
Your cup must be clean and your gas flowing at the right amount,no leaks in o-rings or hoses.
Hold your cup more vertical and keep your filler rod in the gas shield always,no in and out movement.
In short you must get everything perfect to get quality Heliarc Al welds.
Good luck, HowardRoark
Not finding what you are looking for?