Metra Car Audio & Video - Page 8 - Recent Questions, Troubleshooting & Support
Serpentine belt diagrams
The diagram should be posted on the underside of the hood or on the radiator support. If you have the owners manual, it should have the diagram also. If both are unsuccessful, then ask at your parts store as they sometimes have tech bulletins and instructions available on their web sites.
E40841678D what is the 5 digit code
If this was a known code, it would be worthless. You had to set the code and you and only you should enter the correct code. We really can't guess what the code could be.
Replace ignition module
Module should be inside the distributor,or it might have coil pack. Aerial cable should feed in by holding the button on the dash while somebody holds the cable in the aerial hole,two people required.
I have a 1988 chevy corsica. after it has been running for about 20minutes, then left sitting for about 40 minutes, it will not start. it will start right away and then it acts like it is not getting
May sound weird, but have you replaced the fuel filter recently? A clogged filter can cause odd behavior, such as stalling out when you hit the gas after a light turns green, then starting and running fine after sitting for a few minutes. Might also do what you are describing. Another possibility is the fuel pump. If it gets weak, the symptoms are similar to a clogged fuel filter (back pressure from the filter lowers pressure further upstream in the fuel supply line, causing a 'gas starved' condition). If both of those are known good, or if you want to start with something cheaper and easier first, replace the distributor cap and rotor button. A bad or cracked distributor cap can be temperature sensitive. Those are the cheap and (relatively) easy possibilities. Then you get into shorts in wiring harnesses (especially under the hood, due to high heat, which degrades the insulation over time), ECMs, sensors, etc.
Where is the oil pressure switch on Chevy Aveo
Here is the answer shown with a picture: OEM oil pressure sensor is on the oil pump assembly near the crankshaft pulley on the back side of the engine http://www.aveoforum.com/forum/f82/oil-pressure-port-location-oil-gauge-15241/
What are the codes to reset the ABS, Brake and 4/4 lights on a X3 BMW year 2004?
Contact a service department of a dealer that sells your vehicle. Also, it is the responsibility of the tech to have everything back in working order before he asks you to sign off on the repair and that includes making sure no dash lights are on. Personally, I wouldn't trust this repair and would return to the shop and insist they do their job. The fact that these lights are on may bot be a code issue but an indication of improper installation.
Not finding what you are looking for?