Maytag Washing Machines - Page 6 - Recent Questions, Troubleshooting & Support


Turn off the deep clean and extra rinse cycle options.

Maytag Washing... | Answered on Oct 02, 2019


if motor warm when shuts off bad motor or transmission if no voltage when turns off bad board

Maytag Washing... | Answered on Sep 28, 2019


check owners manual or contact manufacturer tech support with model info

Maytag Washing... | Answered on Sep 28, 2019


That error code is for the main control console and the repair is replace that part. It costs almost 300 USD

Maytag Washing... | Answered on Sep 27, 2019


The drum turns on a belt. If you can see behind you can see if the belt is broken or just off of the motor. If the belt is in place you may have a bad motor.

Maytag Washing... | Answered on Sep 27, 2019


Is there any water in machine if so the the pump is not turn ther my but an object obstructing the pump I would check the filter and make sure the pump purpler is turning you can check the by turn it with a screw drive it must turn freely make sure you disconnect power first

Maytag Washing... | Answered on Sep 25, 2019


I u unplugged the machine and it stopped blinking, the lid unlocked but when I tried starting it again the same thing happened. I cleaned the contacts on the lock but that did not help.

Maytag Bravos... | Answered on Sep 23, 2019


It may be a problem with the pressure switch that regulates the amount of water entering the machine?
Due to the age of the machine, it is possible that the pipe connecting the pressure switch to the tub is partially blocked, this will affect the water level, and how the machine progresses through the wash [or not].
Pressure switches are fairly reliable, but it is also possible that it may have failed, but I suggest that you check the small pipe to the pressure switch first.
I hope this helps?

Maytag Washing... | Answered on Sep 10, 2019


Unplug it for 5 min's

Maytag Washing... | Answered on Aug 29, 2019


If the add a garment light is off, then the washer door will unlock after the Pause/Cancel button is pressed twice. The door will not immediately unlock while the cycle is running due to a possible high-water level in the washer, high-water temperature, tumbling or spinning. It may take up to five minutes for the washer to stop spinning and draining before the door will unlock. You will hear the door click when it unlocks.

or

Unplug your washer from the wall outlet if none of the these steps unlocks the door. Use a T-20 Torx screwdriver to remove the three Torx-head screws along the bottom front of the washer.
  1. Pull down on the bottom panel and pull it away from the washer. Reach through the open panel and up to the door lock. Find the release ring below the locking mechanism. Pull down on the ring to unlock the door.
  2. Tip If you must manually unlock the washer door after each wash cycle your drain pump or pressure switch may have failed and would need replacing.
Hope this is helpful

Maytag Washing... | Answered on Aug 24, 2019


Request the diagram directly from Maytag.

Maytag Washing... | Answered on Aug 22, 2019

Not finding what you are looking for?
Maytag Logo

Family Lines

20,044 questions posted

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

Bill Long

Level 3 Expert

606 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Brad Brown

Level 3 Expert

18321 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...