Maytag Neptune - Recent Questions, Troubleshooting & Support - Page 5

Check that the spigot where the Air Dome connects is also clean, it may be full of gunk so the dome gets no water/air pressure...

Always supply a model number, each model has it's own foibles. It is very hard to assist without full details, sorry.

Always supply a model number, each model has it's own foibles. It is very hard to assist without full details, sorry.

Probably drain Pump stopped up or not wirt

Thought it was the door switch/grounding issues/loose wire, etc. Finally found that there was a bad capacitor on the circuit board. It was a 15 cent part that, when replaced, caused all the non-start/power failure indication issues to go away. I've included a picture of the bad part - you can see the slight bulge on the top of the capacitor and a little leakage. Hope this helps.

Check out the door switch to make sure that it closes when you latch the front door. If it does not close the machine will be inoperative - safety measure.