Maytag Refrigerators - Page 7 - Answered Questions & Fixed Issues

It may help to take the ice maker plastic unit out of the refrigerator and rinse with warm water, then dry. There may be ice blocking the flap from closing. Also, check to see that the plastic unit is fully seated as it should be in the refrigerator itself.

Did you do it yoursel. It may b the fan. Check for pipe blockages. Call a repair man. If you have his work will b warranted

Pull out from wall and expose radiator. If dirty, vacuum or blow it clean.

hi. this drain is in the panel of the refrigerator in the Botton.were the lights at ,, take this panel and you will find the drain

Another area to look into is the control panel itself. Due to moisture seeping under the plastic filament the touch buttons / leds may stop working

Try this site for your manual https://searchmanuals.net/search7/?keyword=%2Bowners+%2Bmanual&gclid=CjwKCAiA8OjjBRB4EiwAMZe6y5_84V3ek15m17m45ZjUS8CJGN8CDmLdMHFmDUai5BTqkctyGuc0KBoCV8sQAvD_BwE

Hi! Please check the manual. There should be info or a contact of their customer support. https://manualsbrain.com/en/manuals/1401540/?page=17

Give it about an hour. May have gone into defrost mode.

Program code is located on the serial plate

Press and hold the Door Alarm keypad.

Press and hold the Freezer Temperature Down keypad within 3 seconds.

Release the door alarm keypad and wait 3 seconds.

The control will display PE to indicate the programming mode.

Press the Freezer Temperature Down once more.

The control will display the current Program Code. This should be the same as the program code on the serial plate. If the code is correct, press the Door Alarm keypad for three seconds to exit.

Press the Refrigerator Temperature Up keypad or Refrigerator Temperature down keypad to change the digit value. The decimal point indicates the selected digit. Press the Freezer Temperature Up keypad to select the next digit. Once the correct program has been entered, press and hold the Freezer Temperature Down keypad until the program code begins flashing indicating it’s been saved. Exit the programming mode by pressing any key.

Pull fridge out and make sure everything isn’t covered in dust.

Did you Press and Hold the "Filter" button for 5 seconds?

Never seen one that wasn’t easy to get out unless it frozen in place. If so, thaw it out.

This site shows the small tabs on the lense https://www.repairclinic.com/PartDetail/Large-Part-Image?imgID=1003776&locID=3336
A small screwdriver gently pull back in the opposite of the tab. Try with just fingers first as ofthe lense is too cold the tabs can snap off.

https://www.amazon.com/Maytag-Refrigerator-Control-Board-12868513/dp/B002ZNE5HY https://www.google.co.in/search?q=Maytag+refridgerator+how+to+reprogram+a+control+board+on+a+maytag+model+mbf22581xeq1&rlz=1C1KMOH_enIN790IN790&tbm=isch&tbo=u&source=univ&sa=X&ved=2ahUKEwjyh9D4uoXfAhVMDiwKHR3qBsUQsAR6BAgBEAE

It’s behind removable panel on inside back freezer wall

usually located at the top center of fridge area covered by a plastic plate

Contact customer service phone# or google search Hotpoint.

evap fan /circuit ---defrost circuit --electronic panel --or internal compressor damaged from power outage

Any frost build up on inside back freezer wall?

Maybe evaporator fan is freezer is making the noise and needs to be replaced