Magic Audio Players & Recorders - Page 10 - Recent Questions, Troubleshooting & Support
I have a horizontal hold problem when I turn the
You seem to have a fault in your TV for a horizontal failure to synchronize with the horizontal pulses.
SInce the model was not mentioned I suppose this must be an older version. It is possible that the sync IC is not working as it fails to lock the vertical and horizontal pulses to stabilize the circuit.
If the entire sections are on one IC then it might be fault.
Now since as you mentioned that the set works fine initially , you might notice that the IC is heating up too soon and hence resulting in the horizontal shift. If so try to use a- freeze it-Spray on the IC and if this brings back the horizontal. then try to see for any faulty capacitors on the IC section, check the power to the IC.
If not the IC must be replaced.
Have a wonderful New Year.
Microphone makes a static sound
Make sure your connections are clean and tight. There may also be an intermittant or broken wire in the cord. See if you can narrow the problem down by holding some parts of the wire stationary and moving other areas. gently shake the mike with the set off and listen closely for loose parts making noise. (The idea is to eliminate the areas that are good and what's left is broken.)
Hope this helps
I hear a "pop" from
very common problem caused by pressure waves, try singing off mic but on axis so maybe a 6inches away.
or buy a pop shield (transparent audio foam to cover the mic capsule)
should sort it out, if this does not work then the mic may be damaged.
hope this helps
thanks for using FixYa
Not finding what you are looking for?
