LG Washing Machines - Page 5 - Recent Questions, Troubleshooting & Support

These any good ? Direct from the LG site:

TV Dimensions with Stand (WxHxD)38.3" x 24.8" x 8.5"and TV Dimensions without Stand (WxHxD) 38.3" x 22.5" x 3.3"

Good luck.

LG Washing... | Answered on Oct 26, 2019

first check the lid switch. its a magnetic switch which tells the machine that the door is closed for it to start its operations. if that switch is OK then maybe your push in button needs replacing.

LG TROMM WM2688H... | Answered on Oct 23, 2019

I had this problem with another model LG washer dryer and the problem was just the tiny switch (6mm x 6mm) on the circuit board had worn out. They cost about 30 pence on eBay and are very easy to remove and re-solder onto the circuit board as there are only 2 pins. This saved a huge amount of money for a new control board.

LG WM-1832C... | Answered on Oct 23, 2019

Spray WD 40 and wipe clean with cloth, not leaving any fibres on the PCV board.

LG Washing... | Answered on Oct 22, 2019

There is also a discharge lint filter on the front lower left that has to seal properly. If the water appears only when washing, you can probably eliminate leaking from the water supply side up to the solenoids controlling the water. The most likely source is a leak in the rubber section between the tub and the front door, a leak in the seal between the door and the washer, a leak or overflow in the soap dispenser, or a leak in the discharge side components. You could probably figure out the source if you could view these areas during a cycle, but that would require some disassembly of the cabinet so that you would need to know what you were doing.

LG WM2101H Front... | Answered on Oct 17, 2019

LE is speed sensor error. Easy replacement. Check YouTube. Are you sure it isn't 'tE" error. Thermistor error. Very common. Videos also on repairclinic.com or appliancepartspros.com.

LG Washing... | Answered on Oct 16, 2019

It sounds like the suspension dampers need to be replaced. Lubricant wears away and when the plastic meet metal it will make those odd noises as tub sways to center itself. I recommend replacing all 4 suspension dampers.

LG Washing... | Answered on Oct 10, 2019

yes go to repair clinic.com type in model number and can get it there and its fast

LG Washing... | Answered on Oct 05, 2019

Check pump for restriction, undo cap at lower right hand side at the front and check for any foreign matter, make sure all water is out of the machine and put a towel on the floor

LG Washing... | Answered on Oct 01, 2019

Are you talking about one of the 7or 8 screws/bolts that hold the stator in place/ and one of them cannot be tightened to stay tight/

LG Washing... | Answered on Sep 30, 2019

Contact an LG appliance parts supplier or LG directly to inquire.

LG Washing... | Answered on Sep 30, 2019

check drain hose if ok check pump if ok check drum seals

LG Washing... | Answered on Sep 28, 2019

check drain hose if ok check pump

LG Washing... | Answered on Sep 28, 2019

could be seized bearings try manually turning the drum

LG Washing... | Answered on Sep 28, 2019

Not finding what you are looking for?
LG Logo

Family Lines

11,898 questions posted

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts


Level 3 Expert

85239 Answers

Cindy Wells

Level 3 Expert

6123 Answers

Brad Brown

Level 3 Expert

18378 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides