La Crosse Technology Measuring Tools & Sensors - Recent Questions, Troubleshooting & Support
1 Answer
Sensor doesn't work
Mine stopped working about 2 weeks ago (May 2018) after about 8 years of service. I had tried the recommended procedure to depress the reset button on the sensor, but it still would not reset / reboot the temperature sensor. I suspect the non removable batteries to be the issue failure so I am about to crack the case open to try to troubleshoot the issue for confirmation.
La Crosse...
|
Answered
on Jun 02, 2018
1 Answer
Changed batteries,now weatherstation does not receive outdoor imformation
La Crosse is very specific about what you should do and how you should do it for a battery replacement.
Begin by removing all batteries, both outdoor and indoor. Install new batteries in the outdoor unit. Allow the time it takes to get from the outside to the inside for the outside unit to initialize and begin sending data. Install batteries in the indoor unit and observe outdoor temperature. You should see indoor temperature as well. Finally, set the time. This last can be tricky as it seems difficult to set an exact time. I have two different La Crosse receivers connected to one transmitter and the one in front of me now is indicating 70 deg F indoors and 80 deg F outdoors.
La Crosse...
|
Answered
on Sep 12, 2016
1 Answer
Why isn't outdoor temperature displayed on indoor unit?
I have a La Crosse unit right in front of me and it is showing +18 F tonight. Saturday, we are supposedly going to sub-zero.
With regard to your problem, La Crosse instructions are very specific about the battery replacement procedure. Remove all batteries from both units, then install new batteries in the outdoor unit. Allow time for the outdoor unit to "initialize" and begin sending temperature data. Install new batteries in the indoor unit and you should see the outdoor temperature displayed.
La Crosse...
|
Answered
on Feb 13, 2016
1 Answer
TX58UN-IT transmit icon is on, does not measure rain.
I had this problem and after 7 days I've heard nothing back from LaCrosse. Problem appears to be a non-functioning magnetic reed switch inside the circuitry housing. It's easy to remove the cover with a tiny phillips screwdriver (mind the small and delicate gasket/o-ring). Then the circuit board is held in with two more tiny philips screws at the bottom of the housing. Removing and replacing the switch will require a low-wattage soldering pencil. I used a Standex-Meder part number ORD228VL-1015 from Digi-Key. Only a couple $, cheap, fast shipping. It appears to be an EXACT replacement.
La Crosse...
|
Answered
on Feb 04, 2015
Not finding what you are looking for?
