KitchenAid Refrigerators - Recent Questions, Troubleshooting & Support


Vacuum all the condenser fins of fluff and dust. Disconnect from the mains supply for 10 minutes. Google make model manual and look in the troubleshooting section. This may help you, replace a capacitor. https://www.applianceblog.com/mainforums/threads/kbls36fkx02-kitchenaid-built-in-working-fine-but-beeping-over-and-over.48650/

Call for Service - Built In Refrigerator - Product Help ' KitchenAid

producthelp.kitchenaid.com > Built_In_Refrigerator > Other Dec 14, 2019 - If the "Call for Service" light is blinking or flashing, try resetting the power to the unit: Power unit down by turning off the circuit breaker(s) for five (5) minutes. Power unit up by turning on the circuit breaker(s). Monitor the refrigerator for a couple of minutes to ensure the error code does not display again.

Service & Support ' KitchenAid

www.kitchenaid.ca > en_ca > service-and-support
Virtually hold your place in line or schedule a call back. Note: Scheduled callback is also available outside of operating hours. Check out more resources below.

FIXED - KBLS36FKX02 KitchenAid Built-In working fine but ...

www.applianceblog.com > ... > KitchenAid
Jan 7, 2015 - We have a KitchenAid built-in KBLS36FKX02 that started beeping every few ... I called KitchenAid to see if I could schedule an authorized repair ... So... the fridge is working fine -- the only issue is the constant beeping. Is there ... ..

KitchenAid... • Answered on Dec 20, 2020


Contact the seller for an explanation

KitchenAid... • Answered on Nov 20, 2020


The ice maker needs to be replaced and it not working anymore.

KitchenAid... • Answered on Aug 22, 2020


Some refrigerators are designed to cycle through the settings. If you continue to press the down switch it may cause the numbers to reach the bottom set number then go back to the highest number and start the cycle over. If so then all you will need to do is continue to press it until it gets to the desired number. That is how LG and Kenmore work at least on the models I have worked with..

KitchenAid... • Answered on Aug 01, 2020


replace the emitter and receiver board. see trouble shooting steps on Jpeg. optics boards - resized-undefined-undefined-0_0.jpeg

KitchenAid... • Answered on Jun 10, 2020


May be able to contact this site below to ask for assistance. List of typical symptoms shown there. https://www.partselect.com/Models/KSRP25FNSS00/#Symptoms

KitchenAid... • Answered on Jun 04, 2020


On my KitchenAid, KRSC503ESS, to clear the PO (Power Out) message, press the 'measured fill' button on the front panel for 2-3 seconds. It is right below the word 'confirm' on the display. The technician told me that you need to confirm that you know the power went out so you don't eat any refrozen food. There is absolutely no information about this in the user manual or on the KitchenAid site

KitchenAid... • Answered on Jun 03, 2020


The blower is poor or somethin restrictd from the evaporator in the freezer area. Also u may need the compressor..or condensor testd. On an old fridge its cheaper to just buy a good used..cause parts n labor

KitchenAid... • Answered on May 22, 2020


This is an ice freeze up in the mechanical release mechanism. Leave the door open for a few minutes. But if you are impatient like me, warm the area with a hair drier for about 20 - 30 seconds, and you should be good-to-go.

KitchenAid... • Answered on Apr 30, 2020


A common reason a condenser fan is continually running within a refrigerator is the thermostat. ... A basic test is to set the thermostat on the warmest setting; if the cooling unit continues to run, even when it's being told to keep the fridge warmer, you have a broken thermostat. https://homeguides.sfgate.com/refrigerator-condenser-fan-always-running-37696.html

KitchenAid... • Answered on Apr 22, 2020


Probably not worth to repair. Likely compressor is gone or loose of freon

KitchenAid... • Answered on Apr 18, 2020


In my Kitchen Aid bottom freezer there is a metal arm(?) that I lift up to stop the ice maker from making ice. When I start running low on ice, I push the metal arm(?) back down for it to make ice again. Hope this is the solution for your Kitchen Aid too.

KitchenAid... • Answered on Dec 18, 2019

Not finding what you are looking for?
KitchenAid Logo

5,299 questions posted

Ask a Question

Usually answered in minutes!

Top KitchenAid Refrigerators Experts

Pieter Vleeshouwers
Pieter Vleeshouwers

Level 3 Expert

2028 Answers

Lawrence Oravetz

Level 3 Expert

10548 Answers

Cindy Wells

Level 3 Expert

6259 Answers

Are you a KitchenAid Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...