If you wish to get some details about microwave oven and its working ; check the site linked here. Pull up older posts....
http://electro-medical.blogspot.com/
If you wish to get some details about microwave oven's working and repair ; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/
If you wish to get some details about microwave oven and its working ; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/
? 3:15
https://www.youtube.com/watch?v=9sQco-DIqQ8
Nov 25, 2013 - Uploaded by RepairClinic.com
The most common reason for replacing the vent damper is if it i... ... video is applicable to the following brands ...
? 1:45
https://www.youtube.com/watch?v=yhvuNOVN0R4
May 8, 2012 - Uploaded by Sparky Channel
For a great price on a Whirlpool microwave: Amazon.com: ... Howto change the direction of a blower fan for ...
The turntable motor would be faulty. Its a common problem in microwave Oven.
If you wish to get some details; check the site linked here. Pull up older posts.
http://electro-medical.blogspot.com/
Kurt,
There is usually a mounting bracket that mounts to the wall and the microwave hooks into that and is held up by the two screws you referred to in your question. Unfortunately, you have not provided enough of the model number for us to look up any info to help you find a new bracket to mount to the wall. Hope this helps!
Depending on the total part number 665xxxxxx a replaceable fuse is located behind the control panel usuallyon the floor of the control cabinet.
on one specific model "not yours" to check out the fuse locations a part number 309796 was found and I've included an image. Values of the fuses change based on specific models.
A typical location is included in the following image.
During previous repairs the fuse holder has failed and has required repair in addition to the fuse being replaced. This work needs to be accomplished by a qualified repair person. Even with power remove voltages remain because of stored engergy in the capacitors.
Hope this has been of help?
fix it.
SE Shorted key 1. Check if cable of keypad has been inserted into connector of main PCB. 2. Check for short between main PCB and connector or keypad and cable. 3. If there is not a problem with connector on main PCB and cable of keypad, replace the main PCB.
the holes are to allow condensation and heat to escape during the cooking process
you will notice that the glass door is made up of many small holes so that you can see the cooking process
the holes are of such a size that the length of the microwave is unable to penetrate and so cause radiation outside the oven
tat is what the oven light is outside the oven proper ( behind the holes section) as the micro waves cannot get to the metal fixture
If you are still concerned , talk with a repair shop
best bet is to take a tape measure and measure the width , the height and the depth, write down those measurements then go to an appliance shop and measure all those on display
Yes they are well protected against accidents, they don't want there customers Electrocuted by there products.............. unless your in some 3rd world country.
Try removing the M/W turntable and placing a shallow bowl upside down centered over the rotating device. Then place your plate on top of the bottom of the bowl. The device will still rotate but will not be in contact with anything.