Kenmore Heating & Cooling - Recent Questions, Troubleshooting & Support

You say the unit produces cold air ??? where are you getting the cold air from???
If your fan does not run in any speed F1, F2 F3. and a funny smell sounds like the motor is bad
Mine works in F2, F3 but not in F1

Kenmore 75085... • Answered on Sep 08, 2019

Put something underneath the front of the unit (like a magazine) so it tilts slightly this should allow the water to get to the condenser area and be evaporated out the vent.

Kenmore Heating... • Answered on Jun 27, 2019

are you making sure to push both breakers completely off before pushing them back on

Kenmore Heating... • Answered on May 06, 2019

AC has a relay, it sounds like it failed on ya. If the unit was on all the time, was it that hot where you were or do you mean switched from AC to fan on all day? From what you said, it sounds like the unit burned its relay out for overheating, meaning thermostat may have originally failed keeping unit on until relay popped. Careful of fire hazard.

Kenmore 76129... • Answered on Oct 11, 2018

Without a serial number you cannot look up on line what the unit age is. Have you cleaned the condenser coils on the bottom and back of unit?

Kenmore Heating... • Answered on Aug 27, 2018

First, I'm not a Kenmore representative. * Check your warranty. Call for support * Contact; * Note; Sears support section might not be working. * Kenmore support; *** The following is for information only.*** * 42-79081 8K BTU; * Install 5K-8K BTU air conditioners; * Common problems; * Trouble shooting; * Call your local refrigeration service or local Kenmore dealer for additional advice. Aloha, ukeboy57 Additional info; * customer's review; * Cleaning; * Elite (smart model); * DIY Fix (May Void warranty); * Installing (larger) units; * Customer cleaning (without removal);

Kenmore Heating... • Answered on Aug 07, 2018

If it's not some sort of built in economizing feature, someone else isn't getting up and changing the temperature while you are asleep and the air conditioner fairy is playing tricks, then the control PCB is in need of repair and will have to be repaired through a sears authorized repair center.
I am a bit surprised that it will allow you to set the temperature to a low 70 degrees as this is pushing the limits of an air conditioner. They tend to freeze the coils at around that temperature.

Kenmore 75050... • Answered on Jun 21, 2018

possibly refrigerant related, likely a call for service in your future. Clean coils and filter first!! If you need further help, reach me via phone at

Kenmore Heating... • Answered on Jun 15, 2018

is the relay side sensitive? installed upright? what's starting amps on compressor? verify all connections tight, obviously replace start kit first but possibly compressor going bad. If you need further help, reach me via phone at

Kenmore Heating... • Answered on Jun 15, 2018

Not finding what you are looking for?
Kenmore Logo

910 questions posted

Ask a Question

Usually answered in minutes!

Top Kenmore Heating & Cooling Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Jay Finke
Jay Finke

Level 3 Expert

1391 Answers


Level 3 Expert

4377 Answers

Are you a Kenmore Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides