Jaguar Logo

Jaguar Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 265 Products
  • 16K Answers

If the engine will not crank over then check the battery, cables and starter relay. If it cranks then spray a little starter fluid into the throttle body. If it starts then you have a fuel problem. If not a problem in the ignition system.

Jaguar Cars &... | Answered Yesterday

I have the same problem on my XK8 2005....did you find a solution?

2005 Jaguar XK8 | Answered on Jul 28, 2020

Use the Ford 2.0l instructions in the Focus manual. Same engine.

Jaguar X-Type... | Answered on Jul 14, 2020

Many cars of that period could be reset by some ignition key sequence.
Try switching from the off position to the on (not start) several times within 15-30 seconds.
It won't hurt anything and might turn off the light.
If the problem is still present that caused the light to go on the first time, it will likely come on again after you start the engine.

I hope the reason for that alarm light has been since corrected.

Some cars needed to have the battery disconnected for several minutes to cancel the memory contents.
Newer cars will not likely respnd to that since flash memory is now common which retains the error code even without power.

1995 Jaguar XJ6 | Answered on Jul 14, 2020

check your fuses and module that control those function on the vehicle

1994 Jaguar XJ6 | Answered on Jul 14, 2020

Lock your doors with key and hold until the alarm activates, then unluck car and start

1997 Jaguar XJ6 | Answered on Jul 14, 2020

Fault code P1178Rich Fuelling Trim, Long Term (AMFR)Check for manifold air leaks, rectify as necessary Check for recorded MAFS fault code, rectify as necessary Clear fault code and perform service drive cycle to verify fault cleared Contact Jaguar Service Hotline if fault still present.

Taken from the Jag service manual.

1995 Jaguar XJ6 | Answered on Jul 14, 2020

The 1995 Jaguar XJ6 is OBDII compliant. You can read engine codes using an aftermarket code reader. You may have to call it a 1996 in order for the tool to read the codes. What you can not read without Jaguar's own reader is the ABS codes. Good luck!

1995 Jaguar XJ6 | Answered on Jul 14, 2020

Reset yes, just lock and unlock the driver door with the key. Turned off no.

Jaguar XJ6 Cars... | Answered on Jul 14, 2020

sounds like the leveling sensor is defaulting...this car is under warranty and should be returned to the dealer to address the only question is is this car showing a fault code on the dash?Normally when their is suspension failure it will show a code...even if you have a malfunction in the shock which will read low pressure in the suspension holding tank the car will throw a I would take it back to the dealer...

2011 Jaguar XJ | Answered on Jun 27, 2020


Jaguar Cars &... | Answered on May 10, 2020

contact a dealer with your vin you wont find it on or in the =car...maybe in the owners manaul

Jaguar Cars &... | Answered on May 04, 2020

The valet key allows you to open the doors, the trunk and the glove compartment. It does allow the car to be started or driven. For any time the vehicle thinks it is being stolen, only the fob can reset it. Double click to lock, double click to open.

You can't remove valet mode, it is part of the BCM computer.

Jaguar Cars &... | Answered on Apr 03, 2020

Use the Owners ignition key instead of the Valet key.

2000 Jaguar XJ8 | Answered on Apr 03, 2020

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2002 Jaguar X-Type
2002 Jaguar X-Type

1,680 Questions

2000 Jaguar S-Type
2000 Jaguar S-Type

1,384 Questions

2003 Jaguar X-Type
2003 Jaguar X-Type

888 Questions

2004 Jaguar X-Type
2004 Jaguar X-Type

686 Questions

2001 Jaguar S-Type
2001 Jaguar S-Type

638 Questions

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers


Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14842 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides