Iomega StorCenter - Popular Questions, Answers, Tips & Manuals
Cannot connect to iomega storcenter ix2 with second computer
Confused dot com.
You say it is directly connected to your first computer, not through a router.
That may be your problem.
Try connecting it to the router. Putting it in the same network as your group of computers, and run the finder software on each pc.
4/29/2017 10:27:03 PM •
Iomega...
•
483 views • 0 helpful votes
Red light is fashing iomega storcenter ix2
I am having the same problem. Once I start the storcenter, blue light start flashing and then in a minute or so it changes to red light. The solutions posted earlier are not clear.
9/7/2012 7:26:59 PM •
Iomega...
•
11,633 views • 0 helpful votes
Store centre will switch on but wont boot up
It's likely caused by a failing drive. You'll need data recovery help.I would suggest http://FreeDataRecovery.usThey offer both online data recovery and do-it-yourself data recovery services.
9/10/2012 10:44:30 AM •
Iomega...
•
273 views • 0 helpful votes
Iomega storcenter ix2-200 hard reset
Please help with this issue.I can access the drives but cannot access the system webpage and configuration. I am using the same ip address as above but page is not loading. the iomega storage manager is also not working even after updating to the latest version. Please help.
1/19/2012 7:04:21 PM •
Iomega 2TB...
•
21,873 views • 0 helpful votes
I have the Iomega ix2
At the back of the drvice there is a little reset swtich, located just above the rear usb port. Take a small object (eg. a paperclip) and press the button for 4 seconds. This should reset the password and disable the security.
8/13/2011 11:47:04 AM •
Iomega...
•
2,352 views • 1 helpful votes
I need to reset the
When you say the reset button doesn't work, do you mean just pressing it doesn't do it? Try holding it down for over 30 seconds.
3/1/2011 5:22:14 AM •
Iomega...
•
4,165 views • 0 helpful votes
I have just bought an Iomega Strocenter iX2 but
The IX2 doesn't have white indicator lights. The IX2-200 does which would mean that the device is healthy and ready for use.
Since you are directly connecting it to your imac via ethernet cable which is the only way to connect to the device as the USB's are hubs.
First make sure you computer is getting an APIPA address 169.254.x.x (x represents randomly generated numbers by the computer), do a factory reset (depressing the reset button on the back for 4-5 seconds) which should restart the device, open a Terminal window (Applications -> Utilities -> Terminal) and type (without the quote marks) findsmb and hit enter. You should see your device populated on that list and you should also see an IP address associated with the device. Open an internet browser window and type the devices IP address into the address bar without the "http://" in front. You should have access to the device now.
At this point you will want to statically (manually) setup an IP for your device with your networks subnet. Once you statically set the IP. Disconnect it from your computer and put it on the network.
Good Luck.
12/18/2010 4:40:20 PM •
Iomega...
•
5,237 views • 0 helpful votes
Forgotten admin password
you can reset it from the back there is small whole which reset your storage and it will reset your dmin password
12/2/2010 8:41:15 PM •
Iomega...
•
3,016 views • 0 helpful votes
Not finding what you are looking for?