Ingersoll Air Tools & Compressors - Recent Questions, Troubleshooting & Support

you wont find it

Ingersoll Air... | Answered on Jul 25, 2020

Ingersoll Air... | Answered on Apr 06, 2020

I have a INGERSOLL RAND SSR ML 18.5 compressor.
I looking for a viton seal 27,5x47,6x6,35 mm

Ingersoll Air... | Answered on Mar 18, 2020

If you have plan to purchase diesel generator set, please refer to

Ingersoll Air... | Answered on Jan 06, 2020

Your location may not have a good constant supply of electricity and you are experiencing variable voltage surges. I would suggest that you get a voltage meter and check the voltage to the motor while it is running under load. It needs to remain constant.

Ingersoll Air... | Answered on Apr 11, 2019

STARTER FAULT 1SL (2SL)- This will occur if the
starter contacts open while the machine is running. It
will also occur if the machine is given the stop
command and the starter contacts do not open. 1SL
refers to the auxiliary circuit on starter contact 1M. 2SL
refers to the auxiliary circuit on starter contacts 2M
and 1S.

Ingersoll Rand... | Answered on Feb 27, 2019

hi there,
well,if your air compressor was shut off this due to pressure switch w/c auto switch off your compressor,the pressure switch acquired already the cut off pressure.if the pressure goes down the cut in set up reached it will start your compressor
to run.
regarding oil spillage when shutting down check the oil level on the sight glass of crankcase
a red line indicate oil should not exceed on that level line,if the oil exceed try to drain oil.,on the side bottom of engine there is a drain plug.until on limit level .,besure that machine is shut off/breaker is off.have a nice day don't forget to rate me,thank's

Ingersoll Rand... | Answered on Jan 19, 2019

Has the power supply been checked? It should reset itself when proper supply power is restored.

Ingersoll Air... | Answered on Sep 29, 2018

possibly the check valve but most compressors shut off at 100 psi
it could be that the motor is not of sufficient capacity to go to a higher pressure and that is why it appears to be struggling

Ingersoll Rand ... | Answered on Feb 22, 2018

check minimum pressure check valve on top of separator cover.

Ingersoll Rand -... | Answered on Jan 15, 2018

say try this troubleshooting manual on your issure sna see if you can get it going again. best i csn do for you hope this helps youout.

Ingersoll Air... | Answered on Nov 19, 2017

Hi my name is Luke and I bought a Ingersoll-Rand 7.5 compressor and won’t start. I noticed it has a wire not connected on the capacitors it’s a blue wire that reads t5 v3 there’s a capacitor with open prong before two start caps and another capacitor after the two start caps , at least that’s what it reads on caps unless they have been wired wrong , being that I would think the start up caps should be wired first from powers supply box , want to know where it went Before I went trying to change capacitors and there’s 5 here’s a pic

Ingersoll Rand -... | Answered on Oct 29, 2017

I don't know if your unit is exposed to the direct sun light if it is I suggest you create some shade , or if this this unit is enclosed is not getting enough air flow to keep cool.
( this air flow helps to stabilized the sensor that stop and start the compressor )

Ingersoll Rand... | Answered on Oct 01, 2017

check and test the capacitor or power source --to long or not correct extension cord --to small a breaker for load start

Ingersoll Air... | Answered on Sep 09, 2017

Does it have separate compressors on tank?. You probably need to adjust cut in and cut out pressure switch. I have seen several air delivery systems that utilize 2 separate compressors, this allowed a backup if the one online failed. The units had unloader valves and the compressor never stops running. A call for air pressure would close unloader valves and unit would pump up and the the valves would unload.

Ingersoll Rand -... | Answered on Aug 04, 2017

Ingersoll Rand likes you to buy their all season select oil for their air compressors, most piston air compressors use an R+O 100 oil it is equivalent to n SAE 30 wt oil.

Ingersoll Rand -... | Answered on Jul 22, 2017

Not finding what you are looking for?
Ingersoll Logo

716 questions posted

Ask a Question

Usually answered in minutes!

Top Ingersoll Air Tools & Compressors Experts

Joe Garcia
Joe Garcia

Level 2 Expert

210 Answers

Brad Brown

Level 3 Expert

18455 Answers


Level 3 Expert

85239 Answers

Are you an Ingersoll Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides