Hyundai Logo

Hyundai Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 845 Products
  • 143K Answers
  • 3M Views

Replace the system.

Hyundai Cars &... | Answered 2 days ago


You need to connect it to a $3,000 scan tool computer to solve an error like that. Likely to be a sensor, MAF, Throttle body, Crankshaft sensor etc

Hyundai Cars &... | Answered 2 days ago


hi did you sort this fault out i have the same problem

2006 Hyundai... | Answered on Aug 01, 2020


ill ask what fork are you asking about here???

Hyundai Cars &... | Answered on Jul 24, 2020


It looks like the throttle position sensor wiring, check with a junk yard about getting a pigtail connector unless you can find one at a parts store. The MAP sensor uses a similar connector but the wires are blue and black.

Hyundai Cars &... | Answered on Jul 24, 2020


The MAP sensor on my 2004 hyndai xg 350 is located on the top passenger side of upper plenum. It would be easiest reached from passenger side 2 10mm bolts/Phillips head and a 3 wire plug. The I at/Mass air is on driver side between air cleaner n throttle body. It's a 5 plug sensor on the black hard plastic air intake tube

Hyundai Cars &... | Answered on Jul 18, 2020


I finally figured this out. I was putting the o-ring on incorrectly. I actually had two o-rings installed.
The o-ring should not be visible when it is tightened down. The plastic should be touching the metal housing. The o-ring sits inside the housing, right above the threads, but not at the top. Two pictures attached._388.jpg
_389.jpg

2006 Hyundai... | Answered on Jul 11, 2020


Slow to turn over engine or failure to start quickly ?

Check battery ,if over 5 years old replace

Check fuel pressure with a gauge on motor
May work but not hold pressure when off,thus
slow to start

Can't have spark plugs in motor over 3 years,
nothing to do with miles on then.

Hyundai Cars &... | Answered on Jul 11, 2020


Mechanics like to remove the glove box to get more working room. Cabin air filters seem to be an afterthought in vehicle design.

Hyundai Cars &... | Answered on Jul 04, 2020


Suraj You should be able to go to any Auto Part Store and ask for a Haynes Repair Manual for your vehicle. It will cover everything bumper to bumper. Last One I purchased was from AutoZone and it cost $29.95

Hyundai Cars &... | Answered on Jul 04, 2020


Haynes manuals are listed for sale online, which can be found by internet search - for example using https://www.google.com

Hyundai Cars &... | Answered on Jul 03, 2020


Pull stereo forward and get the last 4 numbers of serial number off the top of the unit. (It’s quiet easy)Add that number to 1212 and that number is the code. So if the last 4 numbers is 1234 +1234 the code is 2468. Push 1 till you get 2, 2 till you get 4 and so on. 5 is the enter button.
The small sticker is the serial number.
7_20_2018_11_46_19_am.jpeg

Hyundai Cars &... | Answered on Jun 30, 2020


There is a simple solution; you just have to bypass the hood switch, which prevents the alarm from arming as it thinks that the hood is open.
To find the switch, pop open the hood and look at the cross-member on the right of the radiator. Connect the wire to the ground to bypass.
Now you can safely unlock the doors without the alarm going off.

2006 Hyundai... | Answered on Jun 28, 2020


As the coils are identical it doesn't matter what order they are in though it is important they are wired correctly - fortunately this is taken care of by the different lengths of connecting cable.

Matter of diverse interest; each coil is generally only half a coil as they operate in pairs, being wired in pairs and only needing a single trigger to produce sparks for two cylinders. This is the wasted spark principle that has been much used with small 2-cylinder engines for a long, long time.

What this means in practice - a misfire or similar spark problem with a cylinder could be caused by a fault with the other half, the paired coil.
It is best to replace the coils in pairs or at least check the other coil for shorted turns...

Hyundai Cars &... | Answered on Jun 22, 2020


First check the immobiliser is properly disarmed then check for a good spark.

If the immobiliser is OK and you have checked the spark, please repost for further advice.

Hyundai Cars &... | Answered on Jun 20, 2020


790 pages of service info which may provide some help on 98 Accent 1.5 below
https://automotrizenvideo.com/wp-content/uploads/2011/11/manual-de-despiece-hyundai-accent-98-1.5-SOHC.pdf
If you are looking for all equipment which has a connector to the ecu or ecm a wiring diagram would provide info as to where the ecm get info from and where it sends it to.

https://www.cargurus.com/Cars/Discussion-c2203_ds502664
Some general info in link below. Basics of video crank sensor keeps blowing fuse to ecm.
https://www.youtube.com/watch?v=ubkHu4gPbbc

Hyundai Cars &... | Answered on Jun 20, 2020


hi there! i was a master tech 4 hyundai. cant believe no1 has solved this 4 you as yet. please contact myself and i with take you though step by step to resolve.

many thanks

Dominic Hill

2003 Hyundai... | Answered on Jun 17, 2020

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Hyundai Santa Fe
2004 Hyundai Santa Fe

1,447 Questions

2001 Hyundai Elantra
2001 Hyundai Elantra

1,154 Questions

2000 Hyundai Accent
2000 Hyundai Accent

1,113 Questions

2006 Hyundai Sonata
2006 Hyundai Sonata

1,215 Questions

2001 Hyundai Accent
2001 Hyundai Accent

1,057 Questions

Top Hyundai Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14842 Answers

Brad Brown

Level 3 Expert

18402 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...