Husqvarna Sewing Machines - Page 9 - Recent Questions, Troubleshooting & Support

Check the specifications on your sewing machine. Most machines have not yet been upgraded to use Windows 10.

Husqvarna Sewing... | Answered on Sep 15, 2018

2g is pretty big. You may try a smaller stick in case your machine has a limited amount of memory space.

Husqvarna Sewing... | Answered on Sep 10, 2018

This likely is related to thread tension. You might increase that adjustment a bit higher than the book settings. If that does not fix the problem, here are some additional considerations?

Thread Breaking Bunching Looping and Tangling All Problems ONE SOLUTION...

Husqvarna Sewing... | Answered on Sep 08, 2018

Hi Vina, Since you can't get any response to your Menu-Norm-Prog-Rep-Set-or Help on your touch screen but you can get into your stitches, It does sound like you need to re-calibrate your touch screen. Normally you would get into your Set Menu to access your touch screen calibration. But as suggested on another solution. You turn off your Des 1, Holding in the reverse button (bottom left of the eight buttons) and the pivot button (the second one from the bottom of the four buttons) at the same time and turn on your machine. This is the Service menu that pops up (try not to touch anything on this screen, it could really mess things up if you don't know what you are doing) After this screen pops up go over to the eight buttons on the far left of your machine and touch the needle up, needle down button (top right button of the eight) the Calibration Screen will pop up on your touch screen (two plus marks labeled 1 & 2) In your sewing sitting position touch the center of the #1 mark and then the #2 mark. Once you've done that the Service Screen will pop back up. Shut off your Des 1 and restart it normally. Try getting into your different menus- Menu-Norm-Prog Etc. Hopefully that fixed your Calibration issue! ** Note: If the service menu doesn't pop up when trying to hold in these 2 buttons together and turning on your Des 1 the buttons weren't held in properly and you need to turn it off and try it again. Hopefully that helped you out!! Happy Sewing!! Kathy

Husqvarna... | Answered on Sep 03, 2018

Most often reset is done by turning off machine and unplugging it for a period of time.

Husqvarna Sewing... | Answered on Aug 26, 2018

Check to see if the button perhaps is stuck in DOWN position.
A quick spray of WD40 with the nozzle in the gap will free it.

If the button is not stuck there may be a worn contact underneath the button, and a spray of WD CONTACT CLEANER in the same manner usually effective

Husqvarna Sewing... | Answered on Aug 21, 2018

Yes, my mother's machine. I am looking for parts. Can anyone advise where is the best place to get parts?

Husqvarna Husky... | Answered on Aug 18, 2018

It works best with very thick fabrics when the bottom fabric moves with the feed dogs but the top fabric doesn't, ie quilts. Also, helps when sewing slick fabrics.

Husqvarna Sewing... | Answered on Aug 15, 2018

Not finding what you are looking for?
Husqvarna Logo

3,976 questions posted

Ask a Question

Usually answered in minutes!

Top Husqvarna Sewing Machines Experts

Douglas Plant
Douglas Plant

Level 2 Expert

222 Answers


Level 1 Expert

19 Answers


Level 2 Expert

89 Answers

Are you a Husqvarna Sewing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides