Hamilton Beach Coffee Makers & Espresso Machines - Recent Questions, Troubleshooting & Support


Unplug the unit for 30 minutes or longer - it should reset the coffeemaker and the clean light.

Hamilton Beach... | Answered on Dec 21, 2020


Report this potentially dangerous defect to Hamilton Beach.

Hamilton Beach... | Answered on Dec 01, 2020


On my old Hamilton Beach Brew Station the machine made coffee just fine, it would just very slowly dispense the coffee into my coffee cup. The interior of the holding reservoir (this is where the already made coffee sits and is kept warm) was heavily stained by coffee (it was black) and the small dome shaped screen filter (this filter keeps coffee grounds from getting in your coffee cup) appeared black and clogged. I used a product called Krud Kutter available at Walmart. I poured enough of it in the holding reservoir to cover the filter and let it sit for about three hours. It now looks like new. DO NOT run this cleaner through the coffee making cycle. Dump the cleaner out and rinse the reservoir out several times with fresh water. The final step is to run a coffee cycle using just fresh water at maximum water capacity and just let it sit for a while as you would a brewed pot of coffee leaving the pot ON to keep it hot. This will allow any Krud Kutter residue to be removed.

Hamilton Beach... | Answered on Nov 10, 2020


I guess you already got the answer from experts.
Anyway, if not then check this post hope this might help you,
https://theblackurbantimes.com/hamilton-beach-flexbrew-troubleshooting/

Hamilton Beach... | Answered on Jul 23, 2020


how does one run vinger water thru when it gives you the h20 error when it have water in it? as far as i can tell it won't pump when it has this error?

Hamilton Beach... | Answered on Apr 30, 2020


Take to the store where it was purchased and have it replaced. Warranty
Get receipt.

Hamilton Beach... | Answered on Jan 09, 2020


It sounds like the sensor that switches from brew to keep warm is faulty... so it keeps boiling after it's brewed.
My suggestion to you is to clean it it with vinegar. The following link shows how to clean a ten-cup model. Just use smaller amounts for the six-cup model.
Good luck
https://youtu.be/mdigGqyI6iw

Hamilton Beach... | Answered on Jan 07, 2020


That little screen that lies at the bottom of the bucket needs to be snapped out and the washer replaced. You have to unscrew the bottom, carefully remove the spring loaded lever, ( don't loose the spring) After fishing the lost rubber washer out of the hole, I used a screw driver or other similar item to pop the screen out. ( use care not to poke a hole in screen.) Next replace lever and spring and push the Star ended piece through the bottom and THEN fasten the washer. Replace all excess pieces and it should be fixed provided the washer isn't badly worn. This is the only way I know how to fix it after countless different web pages and searches.

Hamilton Beach... | Answered on Mar 29, 2019


There is a spring between the lever and the o-ring. It may have popped out when you cleaned the pot. That has happened to me before. The spring is necessary to hold the seal down until the lever is pushed.

Hamilton Beach... | Answered on Mar 29, 2019

Not finding what you are looking for?
Hamilton Beach Logo

476 questions posted

Ask a Question

Usually answered in minutes!

Top Hamilton Beach Coffee Makers & Espresso Machines Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Cindy Wells

Level 3 Expert

6220 Answers

Are you a Hamilton Beach Coffee Maker and Espresso Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...