General Washing Machines - Recent Questions, Troubleshooting & Support

check voltage from switch to power board if ok bad display

General Washing... | Answered on Oct 24, 2020

I have super general washing machine model is sgw 620 this machine coming error E5

General Washing... | Answered on Jun 18, 2020

i don't know. i repaired same condition on different washer. it was the lid safety switch/pin contact. i tested
by pushing pencil in hole where safety pin goes.
i slid top off washing machine and moved lid switch back so ' lid pin ' would contact safety switch. if this is the cause, you may need to replace this low cost switch.

General Washing... | Answered on Jan 07, 2020

e3 mean to much water in washer,check inlet valve, are call a techicain to solve your problem

General Washing... | Answered on Jun 24, 2019

go to google. and enter your machine model # for wiring diagrams.

General Electric... | Answered on May 04, 2019

you can google you super general swg 1201 E01 error for instructions to trouble shoot. or try you tube.

General Washing... | Answered on May 04, 2019

The drain on the wall is called a Stand Pipe. It is designed to be higher than the washing machine so that you do not flood the building every time you do a load of wash. The Machine has a built-in pump to pump the water out of the machine when needed.
You will need to attach a washing machine drain hose to the machine. You should be able to find one at Lowes or Home Depot.

General Washing... | Answered on Mar 13, 2019

Run the machine empty to see if you can clear some of the soap residue, E-4 is "suds lock" error and is usually due to using too much detergent.

General Washing... | Answered on Oct 03, 2018

That could be your trouble the washer has adjustable legs turn legs to adjust level. Also check the belt for worn out.

General Electric... | Answered on Feb 10, 2018

the fact is that no manufacturer will give you part nos ion safety and legal reasons the only way is to go to a scap yard and y=try to find the same scrap machine for the circuit board, the value of the resistors is irrelevant as they burnt out for a reason that replacement resistors wont fix eric

General Electric... | Answered on Jan 20, 2018

when you let people know what type of machine it is then maybe we could help but go to the manufactures and download the user manual and check in the trouble shooting guide eric

General Washing... | Answered on Jan 02, 2018

if you are familiar on how to use an electric multimeter
this is what you do access to the motor which does the washing / spinning find the cable that are attached to the motor remove cables screw them on to a separated connecting block now you select a program ( awash ) with no laundry start the program then set you meter to volts hold the meter prongs on the cable that you have already put into the block hold firm the prongs in each wire you then should get voltage ( hold for 5/8 minutes if the voltage do not get interrupted there is nothing wrong with the control board but the motor is faulty and vice versa

General Washing... | Answered on Jan 02, 2018

You can download GE owner's manuals here.

You can GE order parts and accessories here.

General Electric... | Answered on Jan 01, 2018

Not finding what you are looking for?
General Logo

361 questions posted

Ask a Question

Usually answered in minutes!

Top General Washing Machines Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

Richard C Cohen
Richard C Cohen

Level 2 Expert

171 Answers

Cindy Wells

Level 3 Expert

6195 Answers

Are you a General Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides