Galaxy Radio Communications - Page 5 - Recent Questions, Troubleshooting & Support
How do I put talkback into a Dx33?
it can be done but it is a long process . check out www.cbtricks.com they have the information you need about talk back . if what they have isn't what you want you may have to google it for the information you want.
9/1/2015 7:15:08 PM •
Radio...
•
Answered
on Sep 01, 2015
I have galaxy cb 93 t I just installed it on a brand new Volvo truck all my nb/anl-+10 kHz - pad lights are red is that means bad ground or do I need to ground the antenna any ideas thank
I would start there and ground the antenna to the chassis. Volvos' are made of fiberglass and fiberglass has no ground plane so you have to create one by grounding the antenna to the chassis. If you are using the antennas supplied by the truck be careful because they may not even be connected to the radio at some point in between the radio and the antenna . Get a volt ohm meter and disconnect the coax from the radio . Now take the pl-259 connector and make the coax long enough ( stretch it out ) so you can get the meter connected to the coax . Set the meter on ohms with sound and see if you have a connection . If you do then you can use the antenna provided. If not you may want to try to find the problem or just go get a new set of antennas ,match them up and make sure they are grounded and you should be good to go. remember you don't need a perfect match of 1.1:1 which is excellent but anything under a 2.5:1 is good.
8/10/2015 12:50:34 PM •
Radio...
•
Answered
on Aug 10, 2015
How to turn down the deadkey on galaxy 48t to 4
You can turn down VR18 which is your low power but as you turn it down your high power may go down also. If that's the case then you have to adjust L40,L42,L43,and L44 . If you don't have a scope don't even try it . 10 watts low may be the lowest you'll get. You can also try changing a few Elec. caps. to bring it down more and thats where the scope will really be handy.
6/28/2015 6:32:06 PM •
Radio...
•
Answered
on Jun 28, 2015
Where is the modulation pot on the dx 919 v 16
did you use a meter when you set the pot? there are two pots to adjust . one for high modulation and they other for low modulation . Apparently you didn't read the schematic good enough.
3/4/2015 9:49:01 PM •
Radio...
•
Answered
on Mar 04, 2015
Not finding what you are looking for?