Fujitsu Cameras - Recent Questions, Troubleshooting & Support


Sounds like the card might be corrupted, (broken software). Try another XD card in the camera then in the PC. If it's an old card, they can wear out if used a lot or over a long time. There are also rare occasions where a new one can be faulty.

Fujitsu Cameras • Answered on Feb 02, 2018


I assume you removed the lens cap...;-)
If both the viewfinder and the screen is black, it is most likely an error on the CCD. If the viewfinder is OK, but the screen is dead, the problem is probably the LCD.
Hopefully you still have warranty on the camera?

Fujitsu Cameras • Answered on May 03, 2016


I'm afraid this camera does not have any possibility to do manual focus. Not with stills and for sure not with recording video. The only thing to help you focus on a certain object, that is not in the centre of the frame, is the focus lock. You have to point at the object you want to focus on, then press focus lock and than you can choose the composition you want to shoot. Focus lock occurs when you press the shutter release button half. For video, the manual only says put the rail on the film camera and press the shutter release button once. The video will be stopped after 12 seconds. (or when you press the button again. That is all.

Fujitsu Cameras • Answered on Nov 21, 2013


Had exactly the same problem with my fujifilm j32, after reading a few things on the net and definitely couldn't be bothered to waste money and time sending off a camera that cost a few quid I took matters into my own hands!
I turned the camera on and quickly grabbed the lens to stop it retracting again, once it was held out I gave it a good 'wiggle' moving it in all directions fairly firmly!
I then pressed the on/off button again to switch it off and then turned it back on and low and behold it turned on and worked perfectly after!
Hope this helps others cause it could save you a lot of time and money!

Fujitsu Cameras • Answered on May 03, 2013


You don't need to install anything.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

Fujitsu Cameras • Answered on Apr 15, 2013


Try NOT connecting your camera to your computer.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

Fujitsu Cameras • Answered on May 10, 2012


Try formatting your memory card in your camera. If that fails or doesn't solve the problem, try another card.

Fujitsu Cameras • Answered on Apr 17, 2012


The manual for this camera can be freely viewed, downloaded and printed - here. You may want to review the manual first to refresh your memory of the camera's operation and functions.To your question - page 18 describes using the trash can icon to delete the current image (the one being displayed) and page 41 details deleting unprotected pictures. Page 65 details how to remove protection from pictures so that they may be deleted.I hope this helps & good luck!

Fujitsu Cameras • Answered on Mar 22, 2012


HiMay be the battery's inability to hold charge.Try replacing the battery and see what happens.Hope it helps.

Fujitsu Cameras • Answered on Feb 20, 2012


You can download the manual from the manufacturer's web site at
http://www.fujifilm.com/support/digital_cameras/manuals/pdf/index/f/finepix_f50fd_manual_01.pdf

You don't need any additional software to use the camera. The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.

Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program, such as the free Picasa ( http://picasa.google.com ).

Fujitsu Fuji... • Answered on Mar 31, 2011


SD and SDHC cards have a slide switch along one edge. The position farthest from the contacts locks the card, protecting it from writes. The position nearest the contacts unlocks the card. If the switch is already in the proper position, slide it fully the other way and then back again.

Fujitsu Fuji... • Answered on Mar 21, 2011


You have to format the memory card in your camera.

Fujitsu Cameras • Answered on Feb 28, 2011


There should be a metal tab on the memory card.Pull out the card.The tab slides back and forth.One way is locked,the other is unlocked.Slide the tab to the other position than it is in now.You should be all set.Good luck,Greg

Fujitsu Cameras • Answered on Oct 31, 2010


Hello

The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the probability is that you will have to get it fixed by a professional.

Use these at own risk as it may further damage the camera.

Firstly , try connecting your ac adapter or usb cable.

Try holding the shutter button while switching on the camera.

Look at the lens , and if some of the lens 'circles' is misaligned or not concentric then try wiggling it (while holding camera lens down).

Try gently pushing or pulling the lens when it extends but this is risky as it may cause the lens barrel to slip out of its guidance system.

Another way to do this is to place the camera lens down on a hard surface and then power it up. Be sure to use a soft cloth or something similar as to not scratch your lens or casing. Let the lens push the camera up and down a few times and sometimes the little resistance provided by the camera is enough to get things going again.

Try hitting your camera near the lens on the body with the soft tissue on the palm of your hand.

Other than that , I would take the camera to a repair center for a evaluation to see if it would cost more to repair than to replace the camera.

If it is still under warranty I would suggest you take it in before trying any of these steps and remove any off-brand batteries or accessories as some stores are really fussy about warranty repairs on camera's with non-brand accessories.

Hope the advise is useful.

Regards
Andrea

Fujitsu Cameras • Answered on Sep 14, 2010


I just pulled apart the camera, everything inside was intact. No cogs broken. couldnt find anything to fix (not a camera expert by the way).

In desperation even put some WD40 on the lens barrel - still no luck.

Camera turns on - barrel is stuck out. Wont zoom, wont go back in and wont take a photo.

Daughter's camera and she says she didnt drop it but just saw it on her desk with the lens out...

Would be good if someone could shed some light on the problem.

Fujitsu Cameras • Answered on Jun 03, 2010


I have similar problems, first it got off by it self all the time, when I was staring the zoom, then I went to Fuji. Afterwards the camera is starting and it goes off by itself. After 6 times it remains on

Fujitsu Cameras • Answered on May 22, 2010


The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.

Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive. You can also go to the manufacturer's web site at http://www.fujifilm.com and download their software.

Fujitsu Cameras • Answered on May 17, 2010

Not finding what you are looking for?
Fujitsu Logo

87 questions posted

Ask a Question

Usually answered in minutes!

Top Fujitsu Cameras Experts

Rob Hill
Rob Hill

Level 3 Expert

1426 Answers

Harrie

Level 3 Expert

6746 Answers

Simon Atkinson
Simon Atkinson

Level 3 Expert

2107 Answers

Are you a Fujitsu Camera Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...