Frost Refrigerators - Recent Questions, Troubleshooting & Support


Start getting paid each month more than $17,000+ just by w0rking 0nline from home. Last month i have earned and received $18539 from this easy 0nline j0b. This 0nline j0b is just amazing and regular earning from this are just awesome. Start making extra dollars 0nline just by follow instructions on this website....HER
Heres what I do

... .............. http://www.jobs120.com

Frost... | Answered on Feb 11, 2020


SOUNDS LIKE YOU NEED TO CALL THE LOCAL REPAIR SERVICE AS EITHER THE AUTO DEFROST TIMER HAS FAILED OR THE ELEMENT ITSELF

Frost... | Answered on Nov 07, 2019


PROBABLY NOT BECAUSE THE LIGHTS INSIDE MAKE IT WARM INSIDE AND ITS COLDER OUT SOOO CONDENSATION WILL FORM

Frost... | Answered on Nov 03, 2019

Tip

Refrigeration circuit charge


It would help to have refrigerant type.
The pressures will vary according to load, as when it is first started up. The best way is to weigh the amount of refrigerant charged. By charging by feel, can read the compressor current draw, it is safe to not exceed 1/6th of the compressor LRA. Can charge slowly by filling the evaporator to feel cold refrigerant from entrance to exit.
Condensor may fill with the bottom 1/3 cooler than the hot/warm top. Overfilling will overload the compressor, frost appears on the suction line, first portion of the evaporator may not cool off and actually be warmed.

on Sep 01, 2019 | Refrigerators


If it is full of food & you can't see the back this happened to us; see if the plastic striping that runs down the back corners got shoved down out of proper placement. It's suppose to seal like weather striping or caulk. It will cause the problems you're describing. Around the door too bottom as well. The inside of ours got smudged down & had no clue til I had to start removing the contents.

Frost... | Answered on Aug 21, 2019


Does you ice dispenser serve ice through the door? If yes, then It's likely that room air is entering your freezer through the ice exit, and condensing as ice on your ice maker.

It's a very common problem; The flap isn't sealing tightly after ice is delivered through the chute. Clean you ice maker, removing all the ice, and then stuff the exit chute with plastic grocery bags. The bags will force the flap tight against the chute, and add a layer of insulation from room air. Keep an eye on ice development, for a few days, and if you're confident you've found the problem, order a replacement ice door.

Frost... | Answered on Jul 01, 2019


Possibly the door isn't shutting completely. Here's a YouTube video where another guy had a similar problem and how he solved it.

https://youtu.be/GfQfGdsbIOc

Frost... | Answered on Jun 21, 2019


temp too cold and door seal not effective are 2 reason for this
48 F is too cold for wines (8.8 C) and continually opening and closing of the door allows humidity into the cabinet that results in frost and ice

Frost... | Answered on May 02, 2019


CAN NOT TELL WITHOUT SEEING IT BUT SOUNDS LIKE PERHAPS THE DOORS WERE NOT HUNG PROPERLY OR SEALS GOT DAMAGED SOME WAY

Frost... | Answered on Apr 13, 2019


Hello, this sounds like you have a blockage in the drain tube, remove panel back of freezer..you may see ice build up...melt ice with hair dryer/heat gun...you will see a pan below evaporator...melt ice in pan...dry water up in pan with paper towel...now you should see a hole in pan that leads to drain tube...pour some hot water in pan..wait a couple minutes..mop up water and repeat this step 2-3 times....once you have done this find some flexible curatain wire or electrical wire..poke down the hole until you see the water drain..now it is clear..put back panel back and you are good to go. The reason you see water in the Freezer is because the water has been leaking into the freezer instead of running into the drain hole...If you need any further assistance please feel free to comment again. good luck! P.s Please don't forget to rate my solution thanks! Mike.

Frost Inglis... | Answered on Mar 11, 2019


CALL YOUR LOCAL REPAIR SERVICE AS IT PROBABLY NEEDS FREON ADDED , WHICH ONLY THE PRO'S ARE REALLY ALLOWED TO DO

Frost... | Answered on Mar 08, 2019


there will be a drain hole somewhere which is blocked

Frost... | Answered on Feb 02, 2019


Check the gasket where the frost is appearing and below. make sure the surface of the freezer and the gasket are clean and that the gasket is securely fitted to the door. Check for cracks in the accordion folds of the gasket. If damaged, the gasket should be replaced.

Frost... | Answered on Jan 27, 2019


So the freezer is freezing but the inside floor is melting? I'll just throw this out there... I'm wondering if the compressor is over heating because everything behind the bottom grill is plugged with dust. Try pulling the grill off and very carefully vacuuming everthing. The aluminum fins are fragile and bend easily so use the vacuum brush on this. The vacuuming should be done frequently depending on how dusty your house is. TURN OFF THE POWER SO THE FAN DOESN'T GET HIT.

Frost... | Answered on Jan 03, 2019

Not finding what you are looking for?
Frost Logo

192 questions posted

Ask a Question

Usually answered in minutes!

Top Frost Refrigerators Experts

jdthefixer

Level 3 Expert

746 Answers

mcijoe

Level 1 Expert

10 Answers

RudeRude

Level 3 Expert

503 Answers

Are you a Frost Refrigerator Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...