Frigidaire Logo

Frigidaire Popular Questions, Answers, Tips & Manuals

  • 3K Products
  • 135K Answers
  • 3M Views

Did you look in the manual?

https://tweakbox.mobi/ https://wordcounter.onl/ https://tutuappx.com/

Frigidaire... | 152 views | 0 helpful votes


There are a number of reasons why this might be happening. You bets bet if to call a service guy out and let them take a look at it as some things require specialised equipment to troubleshoot.

Frigidaire... | 118 views | 0 helpful votes


https://www.partselect.com/Models/FEQ1442ES1/#Symptoms

click on the wiring link under the
Manuals & Care Guides for FEQ1442ES1
and this will explain how to decipher the flashing lights.

Frigidaire... | 161 views | 0 helpful votes


Due to the cost of parts on this range, I would call an engineer. $310 for the oven control board, $400 for the 2 elements.

The only thing I would suggest is checking the contacts at the back of the back panel. you must have checked the element contacts when you did the continuity test. I have seen contacts get hot and snap off.

https://www.partselect.ca/Models/LGEF3045KFK/Sections/Backguard/?ModelID=6747678&ModelNum=LGEF3045KFK&mfgModelNum=&ManufactureID=4&Selected=BA2790DC09E1C5239A8B7CD13A1069F3169E482E&Position=1&mfg=Frigidaire&Type=Washer&Mark=1

Frigidaire... | 192 views | 0 helpful votes


if you fol;lowed all instructions and removed shipping braces then return for replacement or refund

Frigidaire... | 116 views | 0 helpful votes


possible bad water solenoid on bottom in back

Frigidaire... | 100 views | 0 helpful votes


In my limited experience magnetron failure is common but testing is not easy or safe.
Anyone reasonably competent can check that mains power is feeding the primary of the big transformer but unless you have eht test equipment and some training your testing should stop there and hand it over to an accredited repairer.

The voltage and current on the high voltage side of the transformer is potentially lethal and far exceeds the capacity of equipment available to the handyman..

Frigidaire... | 110 views | 0 helpful votes


As copied from the manual.

Setting a silent control panel
When choosing a function, a beep will be heard each time a pad is pressed. If desired, the control can be programmed for silent operation. Press and hold (start/time) . After 7 seconds, the control will beep once. This will block the controls from sounding when a pad is pressed. To return the sound, press and hold (start/time) again for 7 seconds until the control beeps once

NOTE!
The OVEN indicator light on the electronic display will turn ON and OFF when using the Bake feature and during preheat. This is normal and indicates that the oven is cycling to maintain the selected baking temperature. When the preheat indicator light turns OFF, your oven is ready.

Frigidaire... | 807 views | 0 helpful votes


Unplug it for 5 minutes. If that doesn't work, you may need to empty it of water by lowering the drain hose into a pail lower that the door.

Frigidaire... | 52 views | 0 helpful votes


it is actually 'Sb', you are in Jewish Sabbath mode which prevents anything being turned on or off on a Saturday.

The display shows "Sb" or "5b" while in Sabbath mode.
SB Sabbath Mode
The Sabbath Mode is a feature that disables portions of the fridge and its controls in accordance with observance of the Sabbath and religious holidays within the Orthodox Jewish community. Sabbath Mode is turned ON and OFF by pressing and holding "?" on freezer temp and "?" on refrigerator temp for five seconds.
In the Sabbath Mode, the High Temp alarm is active for health reasons. If a high temperature alarm is activated during this time, due to a door left ajar, the alarm will sound for about 10 minutes. The alarm will then silence on its own and a red high temperature icon will display. The high temp icon will continue to display, even if the door is closed, until the Sabbath mode is exited and the icon reset. The refrigerator will function normally once the door is closed, without any violation of the Sabbath/Holidays.


https://www.google.com/search?q=Error+code+56+on+Frigidaire+upright+freezer

Here is a list of all the error codes.

Frigidaire Refrigerator Error Codes Fault Codes

Frigidaire... | 185 views | 0 helpful votes


The only access to the drain tube is from the inside which would mean removing the inner cabinet or liner - completely impractical and probably a waste of time as a collapsed drain tube is likely to be a sign the insulation is failing.

I expect you will find there will be at least one cold spot on the outer cabinet. A friend had the same trouble. In her case the top at the back was the worst offender and we extended the life by placing a 4" polystyrene block on the top. She mopped out the fridge daily.

I find a curtain wire is the most suitable for poking around in fridge drains.

Frigidaire... | 82 views | 0 helpful votes

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Frigidaire Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Brad Brown

Level 3 Expert

18321 Answers

Cindy Wells

Level 3 Expert

6099 Answers

Are you a Frigidaire Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...