Frigidaire Heating & Cooling - Popular Questions, Answers, Tips & Manuals


Make sure that the cooling coils are clean. Also that the cooling fans are working. It may have lost it's treon and it is time to buy a new one.

Frigidaire... | 32 views | 0 helpful votes


Press and hold the UP and DOWN Temperature Selection Buttons at the same time for 3 seconds.

Frigidaire... | 41 views | 1 helpful votes


It appears to have an electric heater core. See item #12 on the parts diagram

Frigidaire 12000 BTU AC & Heater Window Unit Heat Cool ...


https://www.ebay.com > ...

Find many great new & used options and get the best deals for Frigidaire 12000 BTU AC & Heater Window Unit Heat Cool FAZ12HR2A at the best online prices ... [PDF]

ROOM AIR CONDITIONER Model No. FAZ12HR2_PARTS


ftp.electrolux-na.com > prodinfo_pdf > edison

Jul 4, 2002 - M40L0004.eps FAZ12HR2A Parts.eps. 63611647.eps. Product No. FAZ12HR2A2. Series. Cool/Heat. Color white. Volts. 230/208. BTU-Cooling.

Frigidaire... | 97 views | 0 helpful votes


Could have clipped the low voltage wire outside with a weed wacker, could have blown out the run capacitor or lost a major component! If the unit is buzzing when you turn it on but nothing's running (compressor or fan)then you have a failed run capacitor! The list of things it could be are endless without more info

Frigidaire... | 34 views | 1 helpful votes


Are you sure you don't have a Heat Pump Condenser? You don't list the outdoor unit M#? If it is a Heat Pump system the outdoor unit has to run. Here is the link to the indoor unit. http://enora.nortekhvac.com/literature/a977a.pdf

Frigidaire... | 376 views | 0 helpful votes


with a meter you will need to verify motor is getting required voltage (high and low)Yes, its likely the motor but, do you put one in to see it still doesnt work?

Frigidaire... | 152 views | 0 helpful votes


as long as it isnt leaking on your floor it should be fine

Frigidaire... | 49 views | 0 helpful votes


if both are running you may be low on frreon, inspect for leaks before recharging.

Frigidaire... | 130 views | 1 helpful votes


manca gas

Frigidaire... | 219 views | 0 helpful votes


suspect that the start/run capacitor for the compressor is failing causing excessive current draw
have technician check it out

Frigidaire... | 302 views | 1 helpful votes


This is a loss of communication with the main control circuit board.

Frigidaire... | 851 views | 0 helpful votes


air conditioner thermostats are located at the front/top of the evaporator coil air inlet where they can monitor the air temperature coming back into the unit from the room
most are a small tube or bulb attached to the fins

Frigidaire... | 62 views | 1 helpful votes


According to frigid aired error code table it is regarding a Mode Conflict Error, but without your exact model number, I can't clarify this any further except to say that you have one of the heads in heating mode & the other head is in cooling mode which creates the mode conflict squalling the E7 Error Code, I do hope this helps... But please comment further if I can assist you in any way I will happily do so....

Frigidaire... | 204 views | 0 helpful votes


First thing to try is turning off the power to the machine for a minute and then turn it back on, if that does not fix it then electronics have a brain problem. I have noticed that appliances with electronic panel controls are having many problems, my washing machine electronic control panel is bonkers but never had problems with the old mechanical controls. In order to fix mine I would have to order the whole panel as you cannot replace parts, I'm sure you unit is the same.

Frigidaire... | 95 views | 0 helpful votes


Maybe the surge capacitor on the fan or fan motor is faulty?

Frigidaire... | 360 views | 0 helpful votes


bad heater element or temp sensor

Frigidaire... | 323 views | 0 helpful votes


Do you have 240 volts at the outlet behind the stove? Should have a double throw breaker at your panel. Make sure both breakers are resetting. If that checks out then it sounds like the power dump may have gotten the control board on the stove and will have to be replaced. There is a small possibility that there may be a fuse on the board. All stoves are different.

Frigidaire... | 41 views | 0 helpful votes

Not finding what you are looking for?
Frigidaire Logo

1,384 questions posted

Ask a Question

Usually answered in minutes!

Top Frigidaire Heating & Cooling Experts

Bill Long

Level 3 Expert

606 Answers

jasbo
jasbo

Level 3 Expert

2239 Answers

Brad Brown

Level 3 Expert

18342 Answers

Are you a Frigidaire Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...