Fisher and Paykel Washing Machines - Page 10 - Recent Questions, Troubleshooting & Support

0helpful
1answer

I have a MW612 fisher and paykel washing machine. I turn it on and the 3rd, 4th and 8th lights turn on and start beeping. Nothing stops it until you press start and then the lid lock light comes on a

all tho the manual says a faulty cold water solenoid which it can be i have found that 9 out out of 10 times its not tht but a faulty main contol module
4/21/2018 1:28:11 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

FISHER PAYKEL FAULT CODE 9

if its a top loader that is incorrect it mean machine needs resizing and if tht doesnt work a new main control module
4/21/2018 1:25:50 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

When the machine begins to fill the water stops and starts then shuts off and machine beeps until it is turned off

most likely the rotary positio sensor needs replacing
4/21/2018 1:24:28 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Aqua smart out of balance

most common problem is worn out suspension rods will need new set fitted
4/21/2018 1:23:43 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Bowl is crooked load unbalanced

yes or sometimes it is just not sitting in place correctly
4/21/2018 1:22:20 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Fisher paykel drain pump repair

cannot repair replace only
4/21/2018 1:21:42 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Aqua smart top loading washing washing is leaking

stuck open solenoid
4/21/2018 1:21:23 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Fisher Pyle not getting any water

faulty cold water solenoid or sensor
4/21/2018 1:20:45 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

What is error code 66 on a fisher & paykel IW12 top load washer

this is a faulty transducer which is located on the main board unfortunatley you will need to replace the whole thing
4/21/2018 1:19:54 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Water stop start stop start then lights 3578 come on and continues to beep

most likely a sensor fault
4/21/2018 1:17:56 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Is it possible to change a fuse in an F&P aquasmart washing machine without a soldering iron?

no as it is soldered onto the main board
4/21/2018 1:17:15 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Can a fuse be replaced in a fisher & paykel aquasmart washing machine

normally yes
4/21/2018 1:16:39 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

No power to my MW 512

burnt out pump or faulty main board
4/21/2018 1:16:14 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Error code 49

if its a top loader the code is for a faulty cold water solenoid,some a new one will not fix the problem if so then itsd a faulty main board
4/21/2018 1:15:44 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Fisher and paykel mw511 3rd, 5th, 7th and 8th lights on and beeping

this is a faulty out of balance switch which is located under the main computer module once replace sgould be ll good
4/21/2018 1:13:01 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

My fisher&paykel model mw512 wont start. The lights on the panel board light up but wont respond to any commands. After a few days even weeks being left off it might suddenly come alive but will o

From memory these have a lid switch which is activated by a hidden magnet in the lid on the R H side, take the two bungs out at the front and undo the two screws which are located at the top front of the machine under the lid,lift top up as far as it will go and look undeneath the top,you will see two wire going to a small unit there is one screw undo and pull away to see the switch if swollen or white ish thats your problem,as temporary repair you cut it off and join the two wires together tape them up and try machine
4/21/2018 1:10:06 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer
0helpful
1answer

Trips circuit breaker when turned on at wall switch

short in pump or module
4/21/2018 12:59:29 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Fisher & paykel GW 512 washing machine trips breaker when swithced on at wall

short in the computer
4/21/2018 12:59:02 AM • Fisher and... • Answered on Apr 21, 2018
0helpful
1answer

Why does a fisher & paykel washing machine bowl drop low

its suppsed to as long as it even
4/21/2018 12:58:31 AM • Fisher and... • Answered on Apr 21, 2018
Not finding what you are looking for?
Fisher and Paykel Logo

4,249 questions posted

Ask a Question

Usually answered in minutes!

Top Fisher and Paykel Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8221 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1482 Answers

Ekse

Level 3 Expert

13435 Answers

Are you a Fisher and Paykel Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...