Ferrari Vehicle Parts & Accessories - Recent Questions, Troubleshooting & Support

If you are talking about the plastic parts around the center console, they are sticky most likely because of the heat of the sun and the effect it has on the rubber coated plastics. The only way to correct this is to buy all new parts from Ferrari.

just try to use some fault code scanner to test it.

1. Not sure what color on your ferrari is the wire to connect radio + to but with a voltage tester it shouldn't be too hard to find one that has power when ignition is switched on 2. ground to any metal part of dash that is bolted or welded to chassis should work well. 3. power antenna should be connected to the wire from the radio that has power coming out when ignition is switched on and radio lights up. Again use volt tester to check which wire has power when radio on!

This is a standard problem in Ferrari, you can only treat it and no cleaning can be done as the plastic will drop off. totally. Home

Battery seems worn out you may need to buy a new one

Which model/year do you own?

Do you need to know how it works? what Ferrari are we talking about, whats wrong with handbrake, more information required?

Hi Vincent. With the VIN you should be able to call your closest Ferrari dealer and they will be able to give you the radio code. THEN WRITE IT DOWN ON SOMETHING IN YOUR GARAGE, LIKE THE WALL OR CUPBOARD DOOR

its 14 years old most likely its the switches in the steering wheel need replaced/ fuses for the speed control / wiring ect.

I have had to replace the switches in the steering wheel before when that happens

Are the bonnet and boot close switches making properly? I found with mine that they are not then it goes straight back to neutral as it does not want you to drive with either open. Also it could need the ecu reprogramming as it might've 'forgotten' what it's doing.

What happens is the seals inside the master become contaminated with sediment and breaks the seal that is formed by design. You might be able to find a "rebuild" seal kit. If not, you will need to purchase the entire master cylinder. Once you have replaced it, the way I bleed any brake system is by having one person in the vehicle and telling them "down" which is understood to be 1. do not pump the pedal 2. push moderately down until it stops and hold 3. whilst he is doing this you open the bleeder and when the pedal hits the floor you then close the bleeder and tell him "up". Perform this function until you have all the wheels bled with no air bubbles. Let me know if you need anything else.

Hi! ss519
Do you have guages or electrical meter. Will the compressor run, if the unit is low on freon, the low pressure switch will not let the power feed the compressor clutch. Just need a little more info.
InMrFixIt

Hi.

If the control has 12V input and does not respond, then the electronic board is gone. In that case the whole part is usually replaced.

Unfortunately Ferrari wiring diagrams are not available for free download. You can purchase the full repair manual from one of the websites below:

Ferrari F355 Car Workshop Service / Repair Manual

Here parts for F355S.

Regards.

Ginko

Hello robin... Here is the link to the Pirelli reference site that will answer your question http://www.pirelli.com/tyre/ww/en/motorsport/sheet/pzero_trofeo.html


Joe

Thanks for choosing Fixya!

Please check and fix your relay / solenoid
Regards

4.6 Northstar V8. It is located on the rear of engine (driver side) in front. It is in the the water pump housing cover. Remove air box and intake tube and bottom radiator hose. 2 bolts(believe 10mm) on thermostat housing. These systems are a little finicky about air pockets....so fill slowly and let run at idle until operating temp and let cool and check level.....fill as needed and repeat if needed.

A faulty central locking system might be due to several reasons, such as a blown fuse, faulty solenoid, or electrical wiring issues. Also, it's good to remember the fault might not be with the central car locking system but the key fob instead; over time, fobs require battery changes.