Fasco Water Heaters - Recent Questions, Troubleshooting & Support

here's what Bradford White lists.... Burner Will Not Ignite REASON REMEDY Excess primary air Adjust air shutter to reduce air supply -- if supplied No gas Check with utility Dirt in main burner orifice Clean orifice -- check for source of dirt and eliminate Dirt in gas lines Notify utility -- install dirt trap in gas line Venturi clogged Clean -- check for source of trouble and correct Pilot line clogged Clean -- check for source of trouble and correct Main burner line clogged Clean -- check for source of trouble and correct Defective thermocouple lead Replace with new thermocouple lead Defective thermostat Replace Defective magnetic valve Replace entire control Thermostat set too low Turn temperature knob to desired temperature Heater installed in confined space Provide ventilation by use of louvers in wall or door time for a service tech.

If it has no oil ports, replace the motor

nope, condensate drain clogged

If you take your pipe off the hot side of the water heater, there is a check valve in the pipe that is stubbed up. They vary in style, usually it is like a marble and it gets stuck. It is easier to replace the stub with a brass nipple and put the dielectric fitting back on it.

Sounds like a lack of intake air for combustion.

http://waterheatertimer.org/Leaking-water-heater.html http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#vent Bad vent? Improper vent? Undersized vent? Vent termination cap located on roof has come off? Bird nest in vent pipe? Gene If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

As soon as you pull out the anode rod(and not put it back) the walls of the tank will begin to rust. The sacrificial anode is there for a reason. If it's eaten away, replace it. If it's totally gone, the tank has been being attacked for a while and might be due for replacement.

bradford white blower . Sir this link will provide you with a variety of sources to buy the blower. The average is far below your quoted target. Since this is a nut and bolt with a direct plug or 3 wire assembly, bradford white blower 239 40614 00 . Here lies a different price point. If this blower is out of warranty and its been running a long time. The value of the direct replacement is a far better choice to average, although more, odds; are to revisit it sooner than later without a direct replacement. If you need help to do this job? It can be a do-it -yourself. Make sure the unit is locked out and give it a whirl. If not? The replacement is approximately 2/3 that of your suggested quote. The ball is always in your court. Be safe. Carbon Dioxide does not discriminate, you never hear anyone from the cemetery complaining. If this is iffy. Get a technician. The extra 1/3 may justify the worth of a life investment. Fare. Well.

MOre information is needed in order to have your question. What are you trying to ask with the statement "Load condenser fan".

http://waterheatertimer.org/How-to-troubleshoot-gas-water-heater.html#blowerhttp://www.thetankatwaterheaterrescue.com/forums/forum3/Geneh If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

PUMP check it out does the boiler sound like a kettle boiling if so its over heating and needs descaling

This could be caused by a defective thermocouple,gas valve, limit switch, clogged spud or anything else. More information is needed. Gas equipment should not be serviced by novices. Save your life and property. Hire a professional!