Euro-Pro Sewing Machines - Page 6 - Recent Questions, Troubleshooting & Support
Euro-pro sew & go b410 sewing machine: Diagram on how to thread it?
Am unable to locate a picture of your machine, but the attached link is threading instructions for a 416. Perhaps it is close enough to your machine model to be beneficial:
Euro Pro 416 Sewing Machine Threading Diagram Oh yes, one more HINT: ALWAYS RAISE the presser foot when threading the top thread!Otherwise, search for:Make Model threadingand see if anything comes up that is helpful.Or try this manual:https://www.manualslib.com/manual/918249/Euro-Pro-415qv.html?page=16#manualRemember that sewing machines basically operate the same. Even though the design has changed over the years, the threading process and sequence remains the same.
I'm looking for a manual of Euro-Pro Shark 803XC
Good luck. I've never found anything reference to any online or hard copy for any Euro-Pro. You might try calling HSN or QVC whomever it was that sold these... and see if they can get you one.
I need to know how to adjust the bobbin tension on
There is a tiny screw on the side of the bobbin case.
Mark the **** (in the screw head) position on the bobbin case with tiny dab of nail polish so you will know where the original setting was.
Left/loose and right/tight.
If you are adjusting because the bottom stitching is loose/loopy, first try threading the machine with the presser foot up to see if this solves the problem.
My sewing machine shark euro-pro 361 is jammed. Needle will not move. What do I do
See if you can remove the bobbin from the machine. Most likely the bobbin and upper threads are entangled and have trapped the needle. You can remove the presser foot and loosen the needle from the needle bar (as though you are going to remove it). Then if you get a small pair of scissors in there and start nipping thread pieces and removing them with tweezers, you may be able to loosen it up.
...
My sewing machine is stuck
hi,
1)Check if your machine is set to sew forward.If the spring doesn't appear to be stretched,drop of WD-40 sewing machine oil.
2)The reverse button is attached to the link that moves a lever to make the machine sew in reverse. The lever is spring loaded so it returns to forward sewing when the button is released. Either the spring has come off or there is a bind in the lever(oil it).
3)Some times pieces of thread or cloth gets blocked in it.
post a comment for further assistance.
Thank you for using fixya have a nice day:-)
How Do You Turn Off The Knife
Be very careful. Stitching without the knife could damage the loopers (if the fabric laps over into the looper path). Most upper knives can be disengaged by pushing in and rotating upwards at the same time.
...
Not finding what you are looking for?