Estate Dryers - Page 5 - Recent Questions, Troubleshooting & Support

Reset your breakers and then check wiring. This is probably where it is. If you have fuses, check them or replace them.

Are you talking about a dryer or a heater.

is this your unit or not at all okay

It appears that one or more safety limits have failed. You will need an OHM meter to determine which one has failed.

i would say check your timer and motor.

It should have level a surface---use a level on sides, side to side etc to see if the unit is out of level---most the feet are metal under the unit and can be turned up or down to level the machine.We had one at home doing this and found if we pushed down on the front top the vibration went away, was supposed to be a temporary fix but put a can (pipe tobacco) with the plastic lids on both ends between it and the wall, worked so well the machine was quiet and level so its been there out of sight but working fineHave someone level the unit with a long level and adjust the four feet as needed.

If you pull it out of closet and replace fuse and it works even after turning off again etc for several times--something is happening when it gets put back---did you disconnect venting connection when you pulled it out?

You will need to replace the timer. Here is the part to order.

Check all of the thermostats for continuity.

i have no heat at all just cold air

You need to check the thermostats on the back of the unit for continuity. Here is a video to help you along.