My Estate washer ETW4400WQ1 will only work with hot water, no cold.
Sounds like you need a water inlet valve. The solenoid on the cold part of the valve isn't letting water in. And it stops at the rinse cycle and won't advance because the rinse cycle uses the cold water side only and if it dies not fill with cold water it will not advance. That will fix your problem
The washer only fills halfway
Has it always done this or just recently? Some washers have lower rinse fills then spray the water on the clothes as it goes through its cycle.
My dishwasher makes a terrible
check the wash pump maybe have a foreign object inside of it or check the pump motor for possible bearing problem.
11/4/2020 11:19:42 AM •
Estate...
•
Answered
on Nov 04, 2020
The agitator on my estate heavy duty super capacity washer only moves in one direction causing the clothes to tangle around it. It doesn't have a belt. What would the issue be?
With no model number it is impossible to be precise. First check the easy (and cheap) possibilities. The agitator has small plastic pawls (dogs) inside the upper agitator half that ratchet around the notched ring on the lower agitator half. You can see these if you pull the fabric softener cup, remove the agitator retainer bolt and lift off the upper agitator assembly. Agitator dogs (a set of 4) should be $4 to $6. (This assumes your model has a two piece agitator.)
Otherwise, is is likely the neutral assembly is broken or stuck. A small part, but difficult to access - located between the outer tub and transmission top. This type of repair is beyond many folks having limited tools and knowledge.
The outer tub ring on
Large items should be taken to the laundromat. Home machines are not made for that kind of bulk. Warranty will not cover consumer mis-use.
Not finding what you are looking for?