eMachines Computers & Internet - Page 3 - Recent Questions, Troubleshooting & Support

would not recommend it but if the tower is very sturdy and doesn't have a flimsy cover it should hold the wait of the monitor without any problem just make sure not to set the monitor on the side where the mother board is because it may damage it if any kind of flexing is done in that area

eMachines... | Answered on Jul 20, 2017

Your best bet is call a tech to remove them or order a restore disk on ebay. If you tell me the name of the program that is popping up I may be able to point you in the direction of removing it. You can try a program called Malwarebytes go to there website and download the software do the 14 day trial and run the scan see if that will remove it if not you will have to do other more technical actions

eMachines... | Answered on Jul 20, 2017

Try changing the browser you are using.
Also make sure both the browser and Adobe Flash Payer are updated to the latest version.

eMachines... | Answered on Jul 19, 2017

Try unplugging from power source and leaving for about three minutes and then plug it back in.

eMachines W3611... | Answered on Jul 18, 2017

tryed safe mode f5
or f8 last known good

eMachines T3642... | Answered on Jul 14, 2017

Disconnect the power cable open the case and pull the CR 2032 battery out for a minute. That will reset the BIOS. If you have no Beep Codes at all the MoBo might be dead. If this were just a video issue there'd be Beep codes. If there's more than one stick of RAM Pull one try to boot then do same with second stick. if there's only one stick of RAM try reseating it.

eMachines C6537 ... | Answered on Jun 28, 2017

the hard drive needs to be replaced

eMachines... | Answered on Jun 26, 2017

got my phone back hunny xxxxx gia is back agan wraff

eMachines... | Answered on Jun 02, 2017

Usually replacing the coin cell battery fixes the no boot problem. Look on the motherboard around the processor socket. Electrolytic capacitors can overheat. If you see any of them that are bulging (top is domed instead of flat), they are bad. Trying to replace all the bad ones is tedious and expensive. May be cheaper to replace the motherboard.

eMachines... | Answered on Apr 16, 2017

Your computer is running for sh-- because you probably have too many items starting up at boot time and running in the back ground. You have to go into your msconfig files and services,.msc files to turn off unnecessary operations. And virus programs are notorious for using up memory resources and turning computer into a snail. If you have one, get rid of it and stay off the p-rn sites.

It is not the cpu or power supply responsible for the issue. It is the user at fault for overloading the machine's resources. And a new computer will get just as bad if you continue to employ the same habits as you have with this unit.

eMachines W5243... | Answered on Mar 24, 2017

Not finding what you are looking for?
eMachines Logo

Family Lines

2,591 questions posted

Ask a Question

Usually answered in minutes!

Top eMachines Computers & Internet Experts

Lee Hodgson
Lee Hodgson

Level 3 Expert

4810 Answers


Level 3 Expert

1997 Answers

Michael Thomas
Michael Thomas

Level 3 Expert

3053 Answers

Are you an eMachines Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides