Eljer Home - Popular Questions, Answers, Tips & Manuals
Eljer 141-0220 tank cracked
Might have been defective with a small crack from the very beginning and over time it just got bigger and bigger until it just gave way and ........................ Happens
9/10/2017 4:33:03 PM •
Eljer...
•
531 views • 0 helpful votes
Motor doesn't turn on.
Do you have the model number? A lot of these systems use a pneumatic tube to send air pressure to a switch. If you have one of those, make sure the tube is not loose or cracked.
2/20/2016 4:20:50 PM •
Eljer Home
•
412 views • 0 helpful votes
Runs with out filling tank
Have a really good look at the alignment do they both mate properly/? Also check the seat at the bottom where the flapper closes, if it has any rough/uneven spots on the edge, or nicks etc, it will not seal properly. If you have to push it down to get it to close, is the ball dropping as it should or getting jammed on the rod, etc? Other thing to consider, is your water pressure higher than usual? Higher water pressure will cause back flow at the flapper and keep the flapper from dropping as it should.
1950's Eljer Murray toilet ballcock troubleshoot
Your best course of action is to replace the whole ballcock assembly with a new one. I recommend the Fluimaster 400a it is a different design but it will work well with your toilet.
Hope this helps
Bob
50 GCM listed section fitting hydro bath hbs
This sounds like you are referring to the suction cover. The fitting with all the little holes in it.
These are removed by taking the two screws out of the face of the suction cover and removing it.
You can then clean it and install it back the same way.
US Parts Center
5/25/2014 5:50:09 PM •
Eljer Home
•
83 views • 1 helpful votes
Not finding what you are looking for?