Electrolux Washing Machines - Page 7 - Recent Questions, Troubleshooting & Support

0helpful
1answer

We have an Electrolux EWF12832 front loader washing machine and it doe not intake and pump out water so won't go through any wash cycles. Any one can instruct how to reset it? Thanks Ron

Make sure water is on with cold connected to cold and hot. Make sure screens in hoses and valve are not clogged with debris
1/28/2019 6:36:38 PM • Electrolux... • Answered on Jan 28, 2019
0helpful
1answer

Electrolux washingmachine W4300H Tarcho error is why?

The tachometer or tacho-generator has the function of controlling the electric motor and the speed of the motor (rpm). So, could be electric motor blocked for some reason, worn out carbon brushes, faulty tachometer, wiring and finally electronic. After 5 years working of washing machine, by my experience the most common reason is worn out the brushes of electric motor. Dado
1/28/2019 7:45:55 AM • Electrolux... • Answered on Jan 28, 2019
0helpful
2answers

Electrolux front-loader motor doesn't spin - error code EF4

most likely worn out brushes on the motor or faulty motor
1/25/2019 7:52:22 PM • Electrolux... • Answered on Jan 25, 2019
0helpful
2answers

Bra underwire stuck

disconnect from electricity. take back panel off.you will see heater at bottom of tub held in by 1 10mm nut.disconnect wires to it. loosen this nut and pull heater out - you may have to help it with a screwdriver. you can then see into the gap between tub and drum and fish for the bra wire.
tell her not to wear bras with wires!!
1/22/2019 6:59:44 AM • Electrolux... • Answered on Jan 22, 2019
0helpful
1answer

My electrolux ewf1087 at the end of washing going to error

Firs of all check out error code number, then check out what it's mean in service manual booklet. Can be simple problem- drain are dirty, clean up.
1/21/2019 11:02:33 AM • Electrolux... • Answered on Jan 21, 2019
0helpful
1answer

I Hi Friend I got Electrolux model EWF 8576 can wash but can’t rine water still inside cylinder. Can’t you tell me what’s the problem Thanks

Hello, I think that your drain pump is blocked of is faulty. You will need to drain the water from the machine, remove the drain hose from the drain outtlet on the wall. or sink unit. Once you have done this check that the pump filter ( if fitted) that it has not clogged with fluff or other debris, If that is not clogged, you will need to look under the machine and check the hoses from the drum to the pump for items like flimsy underwear, socks, or other small items, these can slow the water flow, stop it, or stop the impellor on the water pump. If that is not blocked. check that the drain hose to the domestic outlet is not blocked, as sometimes if you live in a hard water area, it can block with calcium deposits. I hope this helps?
1/16/2019 4:16:10 PM • Electrolux... • Answered on Jan 16, 2019
0helpful
1answer

I have a Electrolux W3105H commercial washing machine but have an error code E10 always coming up.

10E: Water level is above parameter set (10 scale units) after water discharge
1/16/2019 9:08:21 AM • Electrolux... • Answered on Jan 16, 2019
0helpful
1answer

Electrolux EFLS527UIW washer door won't open.

If you can get to the drain hose and hold it low down, the water should come out allowing you to get to the clothes. Be careful where the water goes though.
1/8/2019 12:50:20 AM • Electrolux... • Answered on Jan 08, 2019
0helpful
2answers

Electrolux front load washer door won't unlock. How do I get the door open? Model number: EIFLW55HIW0......unplugging didn't work

Disconnect power supply. Remove top panel. Now is door lock accessible. Open door, remove door gasket from housing (not from tub), remove two screws and replace door lock. Dado
1/7/2019 9:38:02 PM • Electrolux... • Answered on Jan 07, 2019
0helpful
1answer

What does error EHO in electrolux EDC2086GLW drayer with condensor refers to

The EH0 error indicates a problem with the incoming voltage or the power supply or wiring inside the dryer. If there has been a problem with the electricity coming into your home (brown out or similar), the error will resolve when the power company fixes the issue. Otherwise the control board is not receiving the expected power from the power supply. First unplug the dryer or shut off the power at the circuit breaker. Unplugging the dryer for at least 30 seconds will reset the error message. If you can, plug another appliance into the outlet and check if that works. If there is a wiring fault, get an electrician to check the outlet and wiring. If the problem is inside the dryer, the power supply, the control board and the wiring to the control board will need to be checked. There could be a loose wire, a broken wire or a spot where the insulation has been damaged and two wires are touching. Check all of the wiring harnesses where groups of wires plug into the control board. Replace or fix any damaged parts or wires. The parts diagrams are available here: https://www.ransomspares.co.uk/parts/brands/electrolux/tumble-dryers/edc2086glw%20(91609724100)/ . If the dryer is under warranty, contact Electrolux to have the unit serviced. I hope this helps. Cindy Wells
1/6/2019 4:01:59 PM • Electrolux... • Answered on Jan 06, 2019
0helpful
1answer

EWW12742 electrolux door not opening after beeping

5.5 Opening The Door (from user manual) While a program or the 'Delay Start' is operating, the appliance door is locked and the display shows the indicator 'key symbol '. First set the machine to PAUSE by pressing the "Start/Pause" touchpad. Wait until the door lock indicator 'the key symbol ' goes off, then the door can be opened. If the door lock indicator 'the key symbol ' does not disappear, this means that the machine is already heating and the water level is above the bottom edge of the door or the drum is turning. In this case the door CAN NOT be opened. If you can not open the door but you need to open it you have to switch the machine off by turn the program selector knob to the position " 0 " to deactivate the appliance. After about 5 minutes the door can be opened. CAUTION ! Pay attention to the water level and water temperature. Dado
12/30/2018 6:04:05 PM • Electrolux... • Answered on Dec 30, 2018
0helpful
2answers

Electrolux Perfect steam washer has a faded lcd screen. Very hard to read at this point, can someone tell me how to order and replace it Please?

Thank you for your post, Glen Wagner! In order to get proper replacement parts for your Electrolux washer you would need to have the model number available. I would recommend reaching out to the manufacturer, to guarantee the parts are correct. If you need assistance with installing the parts you may want to consult a professional for proper installation of replacement components. I hope this information has been beneficial. -Matt
12/26/2018 9:34:18 PM • Electrolux 4.2... • Answered on Dec 26, 2018
0helpful
1answer

My Electrolux eco valve started making a huge noise when it was spinning and some of the clothes came out with black spots on them

1) It could be that the washing machine drum has collected greasy residue from previous loads. Try cleaning the drum by running an empty cycle with a cupful of white vinegar. 2) Or could be the bearings. When bearings are on the way out they leave streaky dark marks on the clothes.
12/24/2018 9:20:09 AM • Electrolux... • Answered on Dec 24, 2018
0helpful
2answers

Electrolux washing machine error code e30

Hello sreenivasulu, if you are receiving error code E30, first check if it is a false error code by resetting the power to the appliance by either unplugging it or flipping off the breaker for about 30 seconds. If the error code persists, it could potentially mean a number of things: a pressure sensor issue, defective wiring, valve assembly problem and/or control board issue. I would strongly recommend connecting with an expert technician to assist further.
12/23/2018 11:41:36 AM • Electrolux... • Answered on Dec 23, 2018
0helpful
1answer

My electrolux type EWF10842, on display find error EHO, what mean this error,and how to resset, thanks

The EHO (or EH0) error indicates a problem with the incoming power or an electrical problem inside the washer. Unplug the washer for a while to reset the error code. Next check your wiring and make sure that the outlet doesn't have a fault. If you live in an area with brown-outs or wires that touched during a storm, wait until the electricity is repaired. Then check if the power supply to the washer was damaged by the surge or changing power levels. If these aren't responsible for the problem, you'll need to check the wiring for shielding damage, the wire harnesses and the rest of the washer. There is a parts diagram here: http://docplayer.net/60693214-Spare-parts-list-household-washing-machines-pnc-elc-brand-model-market-electrolux-ewf10842-th-washing-machines-front-loaded.html . I hope this helps. Cindy Wells
12/17/2018 1:57:44 AM • Electrolux... • Answered on Dec 17, 2018
0helpful
1answer

My electrolux washer displayed error code E1. No manual. I restarted and the machine went full cycle but doesn't appear to be spinning the clothes so they finish drenching wet. What is the problem?

https://www.electrolux.com.sg/globalassets/5-support/manuals/en-sg/ewt903xs-troubleshooting-guide-en-sg.pdf
12/16/2018 2:01:10 PM • Electrolux... • Answered on Dec 16, 2018
0helpful
1answer

Electrolux MEX731CAS1 dryer stopps about 15 minutes after start, and won't allow the switch to be turned on.

Bad motor most likely. Will it come back on after cooling down?
12/7/2018 9:56:36 PM • Electrolux... • Answered on Dec 07, 2018
0helpful
2answers

How do I fix error code E21 on Electrolux Front loader washing machine?

It is the customer fault code. Simply turn on and turn off appliance. E11 - problem with fill water E21 - problem with draining water E41 - door open All other errors require service staff !!!
11/24/2018 1:55:40 PM • Electrolux... • Answered on Nov 24, 2018
Not finding what you are looking for?
Electrolux Logo

2,423 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Washing Machines Experts

Brad Brown

Level 3 Expert

19165 Answers

David Shaub

Level 3 Expert

2994 Answers

Cindy Wells

Level 3 Expert

6556 Answers

Are you an Electrolux Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...