Electrolux Kitchen Ranges - Recent Questions, Troubleshooting & Support

According to the service manual, E11 stands for shorted keypad.This can be caused by holding down a key for a short period of time. Here's what it is and what you can do.Please refer to the image for your reference. If the error code appears again after trying this maybe it could be an issue with your EOC ( Electric Oven Control). I would recommend to have a professional check your unit for proper diagnosis and to replace defective parts. Thank you.

Electrolux... • Answered on Apr 16, 2021

There is a sensor that detects the rails being in their slot, the switch allows the cleaning cycle to initiate. The temps of the cleaning cycle are too high for the racks and rails. I was surprised to find this. Since then, acquired alien technology has enabled engineers to develop high temp rails/ racks, or lower cleaning temps. It seems the newer ovens have fewer rail / self clean faults.

Electrolux... • Answered on Dec 18, 2020

It can be one of several fixes depending on the exact model. First reset the display either at the breaker panel, unplug it, or on the display itself using the - and + (depressing at the same time for several seconds) if equipped. On some models it can also be a problem with the latching mechanism and cleaning may be all it needs.

Electrolux... • Answered on Oct 13, 2019

f14 misconnected keyboard cable. 1) verify connection between display board and touch panel (2 ribbon electrical cables).make sure the cables are completely seated into the connection point both ends. If the cables are connections check ok then replace the touch panel. If the problem persists still occurs replace the complete display board

Electrolux... • Answered on Sep 18, 2019

It's ridiculous why would you want to remove the racks in self cleaning mode you want to clean the racks also what good is self cleaning

Electrolux 30"... • Answered on May 08, 2019

Usually all you have to do is hold your finger on the icon until it either locks or unlocks. Otherwise contact Electrolux: USA 1.800.944.9044 Electrolux Home Products, Inc., 10200 David Taylor Drive Charlotte, NC 28262 Canada 1-800-265-8352 Electrolux Canada Corp. 5855 Terry Fox Way Mississauga, Ontario, Canada L5V 3E4

Electrolux... • Answered on Apr 28, 2019

Is the door locked? if it is it won't close all the way if it was in the locked position before it was closed. like if it was programmed for "self clean" without the door being closed, the lock would be engaged still.

Electrolux... • Answered on Mar 08, 2019

Since there are gas fumes this is a dangerous situation and should really have a professional with the right equipment to find the leak.

Electrolux... • Answered on Feb 09, 2019

Could be a bad breaker, or a wrong breaker, in the install instructions it will list the required amperage rating for the breaker. If the breaker is over 7-8 years old, could just be bad internally.

Electrolux... • Answered on Jan 08, 2019

An "F11" typically stands for a shorted keypad. You can reset your appliance by unplugging it or disconnecting power for ten minutes. If you perform this step and continue to receive an "F11" it could be an issue within your EOC (Electronic Oven Control) and I would recommend having a professional come out to properly diagnose your range

Electrolux... • Answered on Dec 25, 2018

Try unplugging it for 5 minutes

Electrolux... • Answered on Dec 18, 2018

Searpartsdirect.com or repairclinic.com

Electrolux... • Answered on Nov 21, 2018

What about it?

Electrolux... • Answered on Oct 17, 2018

Not finding what you are looking for?
Electrolux Logo

504 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Kitchen Ranges Experts

Michael Thomas
Michael Thomas

Level 3 Expert

3056 Answers

ADMIN Canada
ADMIN Canada

Level 3 Expert

37954 Answers

john h

Level 3 Expert

23888 Answers

Are you an Electrolux Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides