Electrolux Air Purifiers - Recent Questions, Troubleshooting & Support

Hi! I hope this tips might help you out .

*Plug in air cleaner and press POWER button until short “beep” sounds. . Press the RESET FILTER button by gently inserting a paperclip into the RESET FILTER hole on the control panel. The light will flash 5 times before a “beep” sounds to indicate the filter has been reset.

Thank for using fixya .

Electrolux Air... | Answered on Apr 13, 2020

Sorry we do not have parts here or parts books,.

Electrolux... | Answered on Jul 06, 2017

How do i replace the power cord on electrolux nimble - Fixya

Sep 11, 2014 - Power cord is frayed next to body, need to replace it. how do i get ....See all Electrolux EL8602A Nimble Upright Bagless Vacuum Questions.

Amazon.com: Customer Reviews: Electrolux Nimble Upright ...


Amazon.com, Inc.Electrolux Nimble Upright Bagless Vacuum, EL8602A ... The rotating brush on/off buttons are located right under the soft-touch power button high up at .... Cord is a $30replacement part, which I'm regretting not doing from the get-go, due to ...

Electrolux... | Answered on Oct 02, 2016


Oven stopped working after self clean

Electrolux Double Oven EI30EW45JS1

After a self clean cycle the top oven stopped heating up. The keypad was operational, but there were no error codes. I determined this was due to the thermal switch being tripped. Unfortunately the oven has to be removed from the wall to get to the back where the switch is located.
Here is what I did:
1) Remove any trim around the oven in prep for sliding it out (see installation instructions).
2) Slide it out with a friend, on to a hydraulic table cart (1 used a 500 lb capacity one)
3) unplug the oven and remove the back panel.
4) Either reset the thermal switch by pressing the red button, or replace it. I found mine located on the upper left (facing it from the front)
5) replace the back panel
6) plug the oven back in
7) slide it back in place
8) replace the trim
The hardest part is getting the oven out, so I just replaced the switch and everything worked fine.

on Apr 30, 2016 | Electrolux EI30EW45JS | 30" Double...

I appreciate your post, friend!

From the information you have provided your Electrolux dryer's displays blinks on and off when you turn the dial and it does not start. This sounds like a possible issue with your door latch or control panel. I would recommend for you to check the door strike and door latch to make sure there is no visible damage. If you do not see any damage this could be a wiring issue within your door latch or control panel. This is not a simple DIY job and I would suggest having a professional out to perform an accurate diagnosis. I hope this is helpful information. -Matt

Electrolux... | Answered on Mar 05, 2015

Not finding what you are looking for?
Electrolux Logo

78 questions posted

Ask a Question

Usually answered in minutes!

Top Electrolux Air Purifiers Experts

ray gallant

Level 3 Expert

70647 Answers

Tom Chichester

Level 3 Expert

60129 Answers


Level 3 Expert

85239 Answers

Are you an Electrolux Air Purifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides