Edu-Science Toys - Page 5 - Recent Questions, Troubleshooting & Support


Unsure if the item for sale on ebay is what you are looking for. You posted in the Toys group of questions.

Ebay item with name LR9309 shown on it.

https://timeswitc.com/tc-1-lr9309

Toys | Answered on Dec 01, 2019


'frugal'

Toys | Answered on Nov 28, 2019


This might be a bad wheel seal on the bearing. You can tell by the odor if it is gear lube from the axel or hydraulic fluid from a brake cylinder.

Toys | Answered on Nov 22, 2019


Maurice Pincoffs Canada
www.pincoffs.ca 1 888 707 1880
You will need the model number for any customer service or inquiry. You can find this number on your warning lable of your trampoline.

Toys | Answered on Nov 17, 2019


There are hundreds of sites now that offer free learning and pre-school games. Some of them ask you to sign up after a certain amount of use on the site, but it gives you a chance to figure out which ones you like best. Never pay in advance for online learning games unless you've tried them out. Here are just a couple of examples - http://www.time4learning.com/preschool-games.shtml or http://www.ezschool.com/Games/PreK-G2.html

Toys | Answered on Nov 06, 2019


www.toyday.co.uk/shop/crystal-growing-kit-instructions/info_12.html - 33k -

try this url--it is pretty much similar to all the kits.

cindy

Toys | Answered on Nov 03, 2019


i don't know. symptoms suggest hydraulic fluid level may be low. check and if low, top up using correct fluid.

Toys | Answered on Oct 30, 2019


There are 6 rubber foot pads that under each one is a screw. I had the same problem and we found out that there were screws under the rubber foot pads. Once we were done we glued the rubber foot pads back on the lionel lamp. (Lionel Train Desk Lamp)

Toys | Answered on Oct 24, 2019


CONSIDER USING WELL SANDED SMALL BLOCKS AND ODD SHAPED PIECES OF WOOD. PINE IS
EASY TO WORK WITH. PERHAPS A DOLLAR STORE MIGH STOCK THESE.

Toys | Answered on Oct 24, 2019


Lego set #40327?

Toys | Answered on Oct 15, 2019


You can get 301 to 400 person ac banquet hall in Hotel Green Inn - the best banquet hall in Kolkata. We offer banquet hall, wedding venue, and catering services at the lowest price. Check It: http://www.hotelgreeninn.com/

dewane2-voet0tpqk05sacaxofvb05x0-3-0.jpg

Toys | Answered on Oct 11, 2019


71573 Child Locator Years Made: Fisher-Price Toy Department
Department 6:
Non-Toys & Accessories 1999+
Description: The Fisher-Price Child Locator is an ingenious two-piece device that allows parents to quickly locate their child. One unit is worn by the child, and the other unit is worn or held by parents. The units are continuously linked by communication signals, and an alarm will sound if the signals are severed due to distance or interference, or if the child's unit is removed. When parent press the button on their locator, the child's unit will beep so parents can locate the sound. Designed for parent of children ages 2 to 6 years old. Requires 6 "AAA" alkaline batteries (not included). Accessories: Two-piece device, one piece is worn by the child, and the other piece is held or worn by the parent:
  • FPT14246 - Child locator.
  • FPT14247 - Parent monitor.
Variations: None. Other Information:
  • FP71573SET1999 - complete set in original box. WFL: 07-AG-21-4-A

Toys | Answered on Oct 10, 2019


A friend of ours gave our son a hand-me-down Woody doll with no string at all. I decided to see if I could fix it...about 4 hours, 1 soldering iron, and the realization that my eyes are failing faster than I thought, I was able to return Woody's voice. I'm sorry I didn't take any pictures, but here's what you'll need to do depending on what you find as you operate.


0. Perform of these steps over some sort of container to be sure that you don't lose any of the small pieces that may be liberated in this operation (particularly a small spring that comes later).
1. Take out the battery pack through his lumbar Velcro. There is a black wire that carries power into Woody's thoracic cavity to a module that houses the electronics.
2. You will have to untie, or otherwise get the string through the hole in Woody's back so you can work on it...I don't know what's at the pull end of the string since the Woody we inherited had no visible string.
3. Cut open the white fabric inside Woody that separates battery pack from the electronics module.
4. Take out the two screws that hold the two halves of the module together. CAREFULLY separate these as there are a couple of wires that run between the half with the electronics and the half with the speaker.
5. If you are lucky, which I was not, all the wires will be intact and you will only have to restring Woody. (Nervous sytem work (i.e. wiring) will require a soldering iron and perhaps the assistance of an additional set of hands...)
6. The string is wrapped around a spindle which is spring loaded on one side (it's the big spring - not the little one). With the spindle side of the module towards you (big spring to the lef), the string *should* come up in front of the spindle, over the top and down through the hole..at least think it should. Again the string was broken in ours and once I opened the module, I couldn't tell which way it was originally.
7. On the right side of the spindle is the mechanism that completes the circuit when the spring is pulled. This includes a small spring, and metal piece that makes intermittent contact when the spindle winds back up after pulled.

So, depending on what you see when you take the module and battery pack out you may find:

0. Oh, of course, replace the batteries just to be safe.
1. The string was just hung up in Woody's back and simply removing the module allowed it to be come free again. Piece of cake.
2. The string was bound up around the spindle in which case you just need to clear it and be sure that it winds up properly when pulled. You may need to rewind the string, in which case you need to lift the right side of the spindle (take care to observe how the spring and metal piece are configured...and DON'T LOSE THE SPRING..it took my 10 year old daughter's eagle eyes 5 minutes to find it after it went shooting off the table)
3. The spring mechanism is somehow stuck. This will require tweezers and some patience to sort out the cause.
4. You may have to replace the string. I found some laying around the house that was close to the small shred that remained in our Woody.
5. Finally, I actually had to solder down 3 wires to get the circuit to work. If you're in this predicament, let me know and I will draw a picture for you of what goes where.

In the end, I got Woody to talk again, though he tends to speak without being pulled from time to time. But I gotta tell you, the feeling I got when he burst out with, "Howdy partner, my name's Woody!" was about the best feeling I've had in a long time.

Good luck, and let me know if you need any more information.

Shawn


Toys | Answered on Oct 07, 2019

Not finding what you are looking for?
Edu-Science Logo

42 questions posted

Ask a Question

Usually answered in minutes!

Top Edu-Science Toys Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Tom Chichester

Level 3 Expert

60187 Answers

ray gallant

Level 3 Expert

70761 Answers

Are you an Edu-Science Toy Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...