E-Machines T - Recent Questions, Troubleshooting & Support

0helpful
1answer

Wavy Screen Began to Show Up Slowly

the monitor is dead the monitor fails on 2nd PC too, easy no, such a simple test. the bad pC works on a good monitor, easy too. monitor OSD screens dead bingo bad monitor flash light shows CCFL dead, bingo CCFL dead. thank gawd you never flashed your BIOS and bricked the PC like millions have done now. and the $150 saved you cash and the bricking loss off all that.btw BIOS never ever leaks out. like water bucket full of holes. IT DOES NOT.! do not listen to kid derps on ebay do not. PC ran great for years but did do this est.. learn to test the unstated monitor first. learn that 2010 and older monitors are all dead now. 20k hours and dead for CCFL is DEAD. or intermittent or dim . flash-glow-magic2-undefined-undefined-0_2.jpg
5/16/2022 6:27:18 PM • E-Machines T6524... • Answered on May 16, 2022
0helpful
1answer

To whom it may concern, Suddenly

and first is , he volume turned to zero or muted? sound from what source, CD or other? mouse a USB mouse or P/S2 mouse????????????? never hot swap, any P/S2 device ever. PC off only. allowed. no100mA not problem for USB unless other things USB are overloading the VBUS 5v bus. connections not told at all. first off, exteRnal speaker are powered, or are dead. 3.5mm round plug goes in the green 3.5mm jack on the rear of PC. if usIng a PCI-e sound card it goes there. if goes here the mobo sound must be disabled in bios first. there is front sound jack same think ,called lineout or phones. you can buy $1 ear buds in the dollar store to test all this easy as eating cherry pie in fact , it needs no power to run ebuds a key fact. I can not see your speakers to guess what the are or connectors there and where jacked in to what (3 places green and more wrong.) if bugs fail that means the PC is failing but only allow one jack to be used, 3.5m green (or marked phones or lineout) one bugs , one speakers, one phones. never 2 or more at once. The cause here is bad settings in sound Control panel outputs set wrong. or the sound card of chip sound has no driver. device manager shows if sound drivers are wrong. and first is , he volumn turned to zero or muted? NO OS told XP home new, still using virus maGNET XP:? THE READ PORTS SOUND ARE 3X 3.5MM THE TOP ONE IS SOUND OUT PHONES, LINEOUT with odd colors there not standards, (wow. if no sound card in PCI slot(I cant see PC0 the sound is best used at rear left facing rear of PC and in BIOS That sound chip must be Enable.d and the coin cell battery not dead as all are this old;. specs and good docs and good driver from them are impossible zero. I see audio drivers 2001, if true wow 21 years old XP only the PC came with setup CD , lost that? external speakers
  1. plugged in, rear 3.5mm jack, lineout+phones (not wrong jack)
  2. external speaker needs power and must be turned on
  3. mute off
  4. volume up/
  5. mix sound set for output 3.5mm speakers.
  6. bios for onboard sound not disabled.
  7. OS XP? driver not missing for sound.
  8. xP not infected OMG x10, it is.
5/16/2022 4:46:56 PM • E-Machines T1090... • Answered on May 16, 2022
0helpful
2answers

My dvd player will not play movies,used to work

Hi,
You probably need to update the codecs on the machine, get K-Lite codec pack here, download and install it >>>>>>>>



http://register.sonicdownloads.net/download/index.aspx?sx=a4eb1f90-9cda-4116-8072-e072f715e068



Good luck
5/16/2022 12:16:03 PM • E-Machines T5082... • Answered on May 16, 2022
0helpful
4answers

I am unabLE to play mkv filEs

You can install Leawo Free MP4 Converter, when you install it, it will ask you to install a codec package, after you finish it. you can convert your video to MP4 format easily, or just watch your MKV video with Windows Media Player.
5/16/2022 12:07:08 PM • E-Machines... • Answered on May 16, 2022
0helpful
3answers

How to burn a dvd on a emachines D620?

you can use windows to burn disc but this is for DATA only by click and drag

or you can download some free application software to burn in cd/dvd

here are some free software you can download and use. copy the link to your browser to download.

CD BURNER XP
http://cdburnerxp.se/en/download

ASHAMPOO BURNING STUDIO
http://download.cnet.com/Ashampoo-Burning-Studio-Free/3000-2646_4-10776287.html

BURN4FREE
http://www.burn4free.com/download-dvd-copy-software.htm
5/16/2022 12:04:21 PM • E-Machines T5082... • Answered on May 16, 2022
0helpful
2answers

Dvd boot error problem....

There are 3 step to repair 80200279 error

If you got 80200279 error then there is a 94% chance that your computer has registry problems. To repair 80200279 error you need to follow the steps below:

* Step 1 - Download a Perfect Optimizer,install this error repair tool.
* Step 2 - Click the Repair All Button.It will scan you pc for Free.
* Step 3 - Then click the Repair All Button again and your done! It is very easy to repair 80200279 error.

Here are the url of Perfect Optimizer:http://www.fixerrordiy.com/ttfix-8020027… Source(s): http://www.fixerrordiy.com/ttfix-8020027…
12/1/2018 1:24:38 PM • E-Machines T5082... • Answered on Dec 01, 2018
0helpful
1answer

My e-machine is running really slow, and it takes

change your motherboard.
8/28/2018 12:01:38 PM • E-Machines T5082... • Answered on Aug 28, 2018
0helpful
1answer

My emachine t6524 wouldn't wake

I would best guess it is a bad hard drive that is an older computer and running a deep scan can finish off a dying hard drive. this is 85 percent the cause of your problem ata best guess. you need to have the internal hard drive tested. good luck
1/21/2018 11:30:24 PM • E-Machines T6524... • Answered on Jan 21, 2018
0helpful
1answer

I have an emachines t5082 with vista basic that

Since Vista is a very old operating system you’re going to have quite a challenge finding tools that will solve your problem
- In this particular case you may want to go to a local PC repair shop that would have the old operating system discs you’ll need to restore
- From your description it is tough to figure out whether this is a software problem or if there is something physically beginning to fail on your machine but I can tell you from experience that with the machine of that era you have a hard drives that are at least 10 years old
1/6/2018 1:44:31 AM • E-Machines... • Answered on Jan 06, 2018
0helpful
1answer

Acer desktp internal ram installation needed

you have to use either slots as not the same memory slots
12/23/2017 1:58:57 PM • E-Machines T5082... • Answered on Dec 23, 2017
0helpful
1answer

How do I install ethernet drivers for windows xp on T5026 emachine

Using another PC, download 3DP Net (http://www.3dpchip.com/3dpchip/3dp/net_down_en.php), put it in a pen drive and run it on the T5026. This program can install most Ethernet adapters even offline. Normally I would go to the manufacturer's website and download the driver from there but I could'n find this one.
12/19/2017 1:43:30 PM • E-Machines T5026... • Answered on Dec 19, 2017
0helpful
1answer

I have an E-Machines T6524 and the ATI Radeon

You'll need to replace the Graphics Card with one that supports the OS you are using. Look to eBay for one
12/3/2017 7:41:09 PM • E-Machines T6524... • Answered on Dec 03, 2017
0answers
0helpful
1answer

I have an older T6524

If there is a connection for the SATA drive, the bios should see it. You'll have to go into the bios setup (hit F2 key repeatedly on reboot) and look around until you find the setting. I cannot tell you exactly where it is, as you may have a different bios version. I suggest you plug the drive cable into the "SATA 0)", plug in the drive power plug, and then hook up the main (110 volt) power cord. Don't forget the power for the new drive. I also suggest you try changing ONLY ONE SETTING AT A TIME. Write down where it was, how you got to it, what it was, and what you changed it to. If that does not work, it will be easy to undo what you did, and try another setting. Years of experience has taught me not to make wholesale changes to the bios. Look for something like "Integrated Peripherals"
10/3/2017 2:40:48 AM • E-Machines T6524... • Answered on Oct 03, 2017
0helpful
1answer

Ok! i need help with

Check to see if unit works with other disks. If it works fine then it is definitely a software issue that is preventing playback of your disk. Install VLC freeware and see if that plays it back.
9/22/2017 1:25:08 PM • E-Machines T3256... • Answered on Sep 22, 2017
0answers
0helpful
1answer

My computer screen will only

It may be because you added a graphics card that is not compatible. It is not your motherboard, unless that card damaged your motherboard.
6/12/2017 5:11:08 PM • E-Machines T2893... • Answered on Jun 12, 2017
Not finding what you are looking for?

3,661 questions posted

Ask a Question

Usually answered in minutes!

Top E-Machines Computers & Internet Experts

Ekse

Level 3 Expert

13435 Answers

Brad Brown

Level 3 Expert

19009 Answers

Mandeep  Singh
Mandeep Singh

Level 3 Expert

1184 Answers

Are you an E-Machines Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

E-Machines Computers & Internet

  • Forum

View Most Popular

  • E-Machines Computers & Internet
Loading...