Dual Recent Questions, Troubleshooting Help & Support

did you try holding "EJECT" for 3 seconds page 32 http://www.dualav.com/support/manuals/xdmar6720.pdf

Blu studio 5 0 factory reset Try this link

Either your volume control is not tracking properly or the audio chip responsible for volume change is not working.

A couple of things here. The yellow wire isn't for an amp; the blue wire is. The yellow wire should be connected to constant power. Secondly, that truck may have a factory amp, in which case you have to connect the blue wires to the remote for that amp, or it will light up, but you will never get any sound.

Go to settings then language and input select keyboards there should be a option in that section to turn it off or on

I recommend taking the phone to your phone carrier's store. They will answer all questions and even set it all up for you for free. Usually, the reason for a dual simcard is because the USA/Canada uses one type of system and EU etc use a different system, and it allows you to switch between the two automatically.

you need to do the hard reset, but that will erase all data inside your phone.

Settings -audio-scroll down to the subwoofer option

• Try Shutting it down with the remote.

• CAREFULLY Spray a little bit of WD40 around the button and press it several times to see if will unstuck.

• Take it back to the store where you purchase the set from for exchange, or to a repair shop.

Here is a link to your receiver operating Manual. Best of Luck, JP Dual XHDR6435 Installation Manual

Most DVD eject system are powered by a small rubber band that can break or just fall off. Going inside the unit will reveal if it has.

Your code is 64324

Hi, I am having the same problem with a RRSC that I have just purchased, the blue eject button on the boot mounted DVD changer lights up but nothing happens when you press it, not even the sound of things trying to happen... Did you get anywhere with your?

Contact the manufacturer or an ICE dealer, who stocks that brand, maybe they can assist you

Open it again and check the ribbon cable for cracks, the one that get drag in and out every time it open and close. Because it is a defect for Pioneer too, and Pioneer would replace it free. Goodluck.

repair your system with vista op

Face wont light up it has power

http://www.productmanualguide.com/newpdf/dual-xd1222-owners-manual.pdf link for user manual at link above. Don't know how much information it iffers Good Luck

The most common is that the cable that activates the camera is touching ground and this activates the camera and has nothing connected as black screen looks