Denon Audio Players & Recorders - Page 9 - Recent Questions, Troubleshooting & Support

Check the front of the unit ,most have a small hole, using a paperclip as a probe on the gear with a to and fro movement you will be able to work the draw open.

Most amps shut down due to a fault in the power amp section. Often caused by bad speaker, cables or connections. Another cause is a shorted output device in the power amp.

Hi! Please check the manual to Denon AVR-1082 Hope it will help you Denon AVR 1082 User Manual Page 15 of 42

Try this, not sure if the same would work for ya.

Swich off the amplifier.
Prior to the process check the wires connecting the speakers are not creating a short circuit which is apparently putting the amplified into a standy mode.

1. Press the "A" "B" and power key all at the same time and hold on to it.
2. The amp will go into a reset mode and will keep blinking till it gives a normal "click" sound and the amp turns on.
3. this process would take about 2 - 3 minutes.
4. You may then release the buttons.
5. If it goes into a standby mode again and does not power on, or the standby keeps blinking, get assistance from the engineer.
6. Once it is on, you shall need to do the resetting of alll the configurations done earlier.

Hope it works, it costed me 3k to get the job done.

The Denon AVR-887 does not support ARC (audio return channel) on the HDMI output. You can find the specifications for the AVR-887 in the manual. ManualsLib has the manual here: https://www.manualslib.com/manual/38390/Denon-Avr-887.html . The specifications are listed here: https://www.manualslib.com/manual/38390/Denon-Avr-887.html?page=77#manual . The page with the monitor connection is https://www.manualslib.com/manual/38390/Denon-Avr-887.html?page=22#manual . I hope this helps. Cindy Wells

The Denon DN-C680 gives ERROR 105 on the display. Why?

Hi.
I think.You should be check IC# TC9274N on ext.in card.
Good luck,Bye