Cuisinart EM - Recent Questions, Troubleshooting & Support
My cuisinart EM-200 doesn't seem to be taking in any water. It turns on, goes through the initial cycles. Then beeps and lights flash indicating there is no water in the resevoir. Although ther
Hi.... The problem is the flow sensor under the EM-200. There are three special screws. Inside there is this flow sensor. It´s a Hall effect transitor (w5029) but the problem is the small magnet in the small turbine inside the sensor. Open it, take the small magnet away, make a hole throught it from side to side and then glue the small magnet in the top side, closer to the sensor. It will work again. Brown wire = GND - White wire = 5Vdc - Yellow wire = pulse...After 1 year and 3 months, the problem appeared again. The same flow sensor. The small magnet was completly rusty. I had to change it with a new one. The problem is solved. You can also buy a new flow sensor at Aliexpress. Go there and look for: " Water Flow Sensor 0.3-6L/min Switch Meter Flowmeter Counter Sensor Water Control 1/4" 1.75MPa DIY Kit" Good luck !!
Cuisnart EM-200 will not stop flashing lights
Different lights have different meanings. However I would go with the water reservoir is empty or not in place properly. It's also possible that the machine is not reaching the proper temperature and that will also cause the light to flash. (Indicates that a repair is needed). (Page 6 in the manual.)
Not finding what you are looking for?