Creda Dishwashers - Recent Questions, Troubleshooting & Support

classroom.google.com/c/NjE5MTMyMDAyMzZa

When you openbyhe compartment it should be full of water, this is where the salt goes. Having never owned one before, make sure you only us granular dishwasher salt, never table or rock salt

Check filter take it out clean and replace it hope this helps

Hi,the inlet vaves the one that lets the water in,I had one go wrong all the machine did was start then make a bang then gos off, replaced inlet valve then water went into machine but then another isue,I think another valve,so rubbished the machine. if the machine is left standing for any lenth of time the insides get corrodid with limescale so realy need to be dismantald and any parts that look suspect need to be checked or if not shore replaced. sorry could not help more, if you wont to have a go replace the inlet valve first, its a cupple of screws and a few clips. x-head screwdriver and long-nose-plyers. all the best.

most likly the immersion is faulty

water valve faulty

not realy

faulty switch

short on wire to oven light

spring broken

twin switch

Check if there is a screen in the supply line, these can become blocked due to scale deposits from the mains. If there is no screen check that the inlet solenoid valve has not got blocked. If none of the above help, check that there is power getting to the solenoid valve when the machine is supposed to be on the fill cycle. If no power is getting to the valve, the timer might be faulty. (You can try hand filling the machine and see if it goes through a cycle, at least up to the rinse stage, this will tell you if the timer control is working).

Yes It's a relatively easy fix, turn off the power then just remove the screws on the inside around door and separate the panel, you will need a star head driver or a hex driver will work to. from the inside you can remove the wire harnesses then unscrew the door latch with a fillips driver and replace. This repair usually takes me about 10 minutes. Good luck