Chicago Pneumatic Air Tools & Compressors - Page 9 - Recent Questions, Troubleshooting & Support
Im looking to buy a air hammer. what is the
It looks like Amazon came up with a name "zip gun hammer" A zip gun is a low profile gun with bullets. The cp716 is a good model. Make sure to get the bits with it. These air hammers do not come with bits most times.
good luck
Joe
2/19/2011 4:08:14 PM •
Chicago...
•
Answered
on Feb 19, 2011
Model 734 1/2 in impact.wont
Yes, if you take it apart you'll find that the trigger isn't allowing air to pass through to the veins of the impact wrench. It's a relatively simple mechanism, where maybe something is broken inside.
If it were blowing air but the veins were stuck, I would say, lubricate it. But, if no air goes through it at all, then the trigger housing houses the problem part.
Have you tried to disassemble the air wrench?
1/21/2011 9:01:30 AM •
Chicago...
•
Answered
on Jan 21, 2011
How many amps does it
If you mean 220 volts then I will guess 30 amps each leg. If you are doing wiring consult local building inspectors, hire licensed electricians. Fire hazard is high if wire gauge does not match amperage load.
12/27/2010 6:36:09 AM •
Chicago...
•
Answered
on Dec 27, 2010
ITS didnt unload its running
Hi, my name is John. Welcome to Fixya. Unplug it and replace the pressure switch. That should do it. Thanks for choosing FixYa....John
11/25/2010 5:07:43 AM •
Chicago...
•
Answered
on Nov 25, 2010
I just hooked up a
Hi, my name is John. Welcome to FixYa. Make sure you are correct in the wiring of that, double check that you are right. Thanks for choosing FixYa....John
11/23/2010 7:08:51 PM •
Chicago...
•
Answered
on Nov 23, 2010
I need to find parts for my old Chicago Pneumatic impact wrench
You may be able to find your parts online but you will probably pay a lot more than you need to. Your best bet is to call or go to a service center that deals with CP. There are 3 different anvils for that particular model so you will have to get the right part number. You can get information by emailing or calling CP for the nearest service center to you.
10/27/2010 11:52:05 PM •
Chicago...
•
Answered
on Oct 27, 2010
My cp772h is running low on power. I am unable to
The biggest problem I have seen with these is the hammer mechanism.Remove the front of the tool and disassemble hammers.Clean them good with solvent and using a paint brush re coat then with a special hammer grease that can be purchased at a local tool repair and supply store.Also check fwd and reverse seals while you have it apart.Check motor veins for wear.Check inlet screen and exhaust for debris.
10/19/2010 5:02:17 AM •
Chicago...
•
Answered
on Oct 19, 2010
Not finding what you are looking for?