Chevrolet Logo

Chevrolet Answered Questions & Fixed Issues

Do you work here? Claim your company

  • 2K Products
  • 580K Answers
  • 8M Views

buy a haynes manual at a partplace

1978 Chevrolet... | Answered Yesterday | 381 views


Thee is no glove box in a 2006 chevy express 2500. There is also no in cabin air filter.

2006 Chevrolet... | Answered 2 days ago | 3,783 views


Align the slim jim with the lock and push it downwards towards the keyhole.When you see the lock start to move, pull the slim jim upward slowly until the door unlocks.

2007 Chevrolet... | Answered on Jun 01, 2020 | 3,903 views


IF YOU HAVE NO CLUE WHERE TO START THEN PAY A PROFESSIONAL TO DO IT .

Chevrolet Cars &... | Answered on Jun 01, 2020 | 96 views


PERHAPS AN AUTO PARTS STORE (NOT ONLINE ) CAN PROVIDE YOU WITH ONE

2012 Chevrolet... | Answered on Jun 01, 2020 | 112 views


IF YOU HAVE NEVER DONE IT THEN PAY A BODY SHOP TO DO IT

Chevrolet Cars &... | Answered on Jun 01, 2020 | 38 views


This post will show you where the fuses are and what they control.
https://troubleshootmyvehicle.com/gm/4.3L-5.0L-5.7L/instrument-panel-fuse-box

1993 Chevrolet... | Answered on Jun 01, 2020 | 552 views


definitely need new ignition cylinder

1998 Chevrolet... | Answered on May 27, 2020 | 200 views


USED TO BE 3/8 INCH BUT WHO KNOWS NOW WITH METRIC PARTS IN MANY PLACES

2001 Chevrolet... | Answered on May 26, 2020 | 84 views


If your vehicle is equipped with automatic climate control, this should help.

Recirculation Operation
The HVAC control module controls the air intake through the recirculation actuator. The recirculation switch closes the recirculation door in order to circulate the air within the vehicle. The outside air switch opens the recirculation door in order to route outside air into the vehicle. Regardless of the blower motor switch position, recirculation is available only in the panel and bi-level mode switch positions. Including the OFF position. The mode switch must be placed in either the panel or bi-level position before the blower motor switch is placed in the OFF position. In order to reduce windshield fogging, outside air is circulated when the mode switch is in the defrost or defog positions. If the recirculation switch is pressed into the ON position when the mode switch is in an unavailable mode position, then the recirculation switch LED will flash 3 times. If the HVAC control module detects a fault with the recirc door the HVAC control module will try to drive the actuator for a predetermined amount of time, to outside air, which is the defaulted position for the recirculation actuator

2007 Chevrolet... | Answered on May 26, 2020 | 18,220 views


The fuel filter on the Cruze is underneath the car on the passenger side. To access it:
• Remove the aerodynamic housing
• Keeep an oil pan underneath to catch the residual fuel
• Use a wrench to open up the filter, and once you see the O ring, start unwinding by hand
• A housing will drop out with the fuel filter-put some pressure, and you can remove the fuel filter.

2012 Chevrolet... | Answered on May 25, 2020 | 4,154 views


TRY AN AUTO PARTS STORE LOCALLY

Chevrolet Cruze... | Answered on May 25, 2020 | 931 views


Here are the torque specifications you need:
• Axle Shaft nut - 177 ft-lb
• Hub and bearing assembly to steering knuckle bolts - 133 ft-lb

2003 Chevrolet... | Answered on May 25, 2020 | 3,467 views


Just repaired code 136 on a 2013 chevy Orlando and it was a detached ground wire on one of the starter bolts causing the fusebox relays not to energise.

2013 Chevrolet... | Answered on May 24, 2020 | 3,072 views


Check that the Idle air controller is not faulty, disconnect it and start the truck again, if the truck starts (running poorly) then replace the IAC.

1999 Chevrolet... | Answered on May 22, 2020 | 383 views


A U1041 code means that communications with the electronic brake control module are lost, and this may have happened because:
• Electronic Brake Control Module harness is open or shorted
• Faulty Electronic Brake Control Module (EBCM)
• Electronic Brake Control Module circuit poor electrical connection
To fix the issue, inspect the issues mentioned above and check that all the wirings and connectors are intact-nothing should be broken or corroded.

Chevrolet Tahoe... | Answered on May 21, 2020 | 3,705 views


Here are the specifications you seek:
• Torque spec on rocker arms is:
o 14 NM (124 in-lbs) plus 30 degrees
• Lower intake bolts:
o long bolts - 13 NM (115 in-lbs)
o Short Bolts - 25 NM (18 ft-lbs)

Chevrolet... | Answered on May 21, 2020 | 2,279 views


First, align the slim jim with the lock and push it inwards in the direction of the keyhole when the lock is visible - pull the slim jim upward slowly until the door unlocks.

2008 Chevrolet... | Answered on May 21, 2020 | 5,882 views


Here are the Torque specifications:
1. Head bolts - 46 - 50.5 lbs
2. Intake & exhuast manifolds - 13.5 - 20 lbs
3. Flywheel - 41.5 - 47 lbs
4. Clutch cover - 13.5 - 20 lbs

2005 Chevrolet... | Answered on May 21, 2020 | 3,550 views

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

john h

Level 3 Expert

23401 Answers

Brad Brown

Level 3 Expert

18342 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...