Champion Garden - Page 5 - Recent Questions, Troubleshooting & Support


Strimmer line is consumed constantly in use either by wear against abrasive surfaces or being snagged against stems and suchlike it can't cut through and so tends to break. With lots of patience a lot of those stems can eventually be cut.

Early strimmer users became fed up with the process of stopping work, upturning the machine and releasing more line and starting over and so in order to maintain sales the bump and automatic feed heads were developed.

You description suggests you are using your low powered grass trimmer for heavier work than it is designed for.

Garden | Answered on Jun 30, 2020


Look between your legs!

Garden | Answered on Jun 30, 2020


all 2 strokes take a 50:1 mix. Thats 2.6 ounces of 2 stroke oil, to 1 clean unleaded gallon of gasoline.

Garden | Answered on Jun 25, 2020


I agree, the teflon rings appear to br the only things that wear (aside from the hole size which could wear from water abrasion, but unlikely). That would explain the metal to metal sound you hear at times because the seals prevent wobbling.

Garden | Answered on Jun 25, 2020


It could be a weak spark but most likely it is not receiving the fuel it needs for full throttle operation.

Assuming the fuel is fresh and there isn't an excess of oil this can be tested to some degree by opening the throttle fully and then partially applying the cold start if it can be applied separately or partially covering the intake of the carb with a finger if it can't.
If this improves things it proves the mixture is too lean and it could be a blockage or a matter of adjustment.

One thought occurs - if it was ok before being idle over winter, it is possible the crankshaft oil seals have lost flexibility and air is being drawn past them into the crankcase.

Garden | Answered on Jun 24, 2020


Trigger available on this one stripped down for parts

https://www.ebay.com/itm/Black-Decker-Belt-Sander-7451-TYPE-2-Parts-Sold-Individually-Or-As-Part-Group-/183926335324#viTabs_0

Trigger & Power Cord : The trigger worked well and there should be ample wire left to tie it into your motor. The cord itself has a lot of damage and tape repairs, but I let it be so that the collar and other parts can be used.

Or the other thing you could do is bypass the switch, fill the hole with epoxy putty and put a sliding light switch in the cord near the sander tail.

https://www.amazon.ca/uxcell%C2%AE-Inline-Switch-Toggle-Table/dp/B07P5YW8TG

Garden | Answered on Jun 24, 2020


fixya doesnt sell products --try manufacturer or online search using make and model

Garden | Answered on Jun 24, 2020


bad battery
not enough to run the ignition and the starter but enough when the starter is not engaged

Garden | Answered on Jun 24, 2020


it's right in their little black box you can't see it the fuse itself will be covered in dry grass. and stuff so you'll never know it's there. and it has one of these bullet in clips it holds it there.

Garden | Answered on Jun 24, 2020


Perhaps the fluid has become contaminated and is foaming and/or one or more filters is being partially blocked after running a while. Perhaps also the fluid is boiling due to a lowered boiling point caused by contamination.

The fact it is ok while cold is likely to indicate the trouble is related to one or all of the above and so cleaning or replacing the filters and replacing the fluid seems the most appropriate initial action and if the trouble persists the next step will be to check the pump is maintaining the rated pressure when hot...

Garden | Answered on Jun 23, 2020


Fixya is unable to suggest sources for Enviroshade canopy poles. You may have to improvise.

Garden | Answered on Jun 23, 2020


you need to resubmit your question including what machine you are having the problem with... helps to have a lot of information versus little...good luck

Garden | Answered on Jun 23, 2020


https://www.manualslib.com/products/Yazoo-Kees-Zmbi48180-7105503.html

Pg 20.

Garden | Answered on Jun 23, 2020


the real question here is what is it??

Garden | Answered on Jun 22, 2020


look in the owners manual or call a local dealer

Garden | Answered on Jun 21, 2020


find and download the owners manual..

Garden | Answered on Jun 20, 2020


I would look on u tube

Garden | Answered on Jun 20, 2020

Not finding what you are looking for?
Champion Logo

38 questions posted

Ask a Question

Usually answered in minutes!

Top Champion Garden Experts

Lawrence Oravetz

Level 3 Expert

10548 Answers

Vernon Taylor

Level 3 Expert

6659 Answers

john h

Level 3 Expert

23424 Answers

Are you a Champion Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...