Bulldog Security Vehicle Parts & Accessories - Popular Questions, Answers, Tips & Manuals

Were you getting bad fuel pressure readings at the manifold? Just curious what prompted you to change fuel pressure regulator and filter (nothing wrong with that of course). I would recommend first checking the TPS (Throttle Position Sensor), second the EGR Valve and third the Catalytic converter. Also, are you getting a CEL and any problem codes?

The issue is the frequency of the remote control often they will have a selection switch to change the frequency. If not the remote & receiver need to have chips changed to adjust the frequency so they do not conflict with the vehicle system

hey larry wrong site this is fixya need to send your gripe to the correct party

i have a chipper and it started giving lot of problems 4 yrs ago, so I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

hello u will find a lot of wiring diagrams and circuit diagrams help books and stuff like this at online places.. like reliable-store for free the girl in the chat box can help u instantly... im a frequent buyer there since Im a mechanic so take help from there

http://www.bulldogsecurity.com/ It will come with instructions based on the one you buy for your car or just call them and ask.

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer... rest is up to u.. U get free manuals

it's obvious, you don't have it wired up corectly either via grounding or via power suppply. it's blowing the fuses because you're prboably pulling too much amperage. you'll need a multimeter to see what levels of voltage and amperage and resistance are registering.

I take help from online websites that have this service like helping in repair some like reliable-store h ave instant help.. others are a bit slow which I don't prefer... rest is up to u .. U can also get free manuals

This is not really a question ...

yes

Check for a burned fuse

replace the starter switch or key switch

Get a auto start remote and try it!

Replace battery?

Does it try and do anything ?

try buuldog manufacturer on line help ,possibly needs programming via sequence on remote button

I would say get the schematics from bulldog and trace the lines, it sounds like either the wiring is bad or one of the relays is bad.

are the battery in the key.fob.good ?

remove the bulldog and mount it again, in another car. see if it does the same.