Buick Logo

Buick Recent Questions, Troubleshooting Help & Support

Do you work here? Claim your company

  • 379 Products
  • 172K Answers
  • 3M Views

https://www.youtube.com/watch?v=hl2aOFpKMGg

This is a video for a rondezvous car but they have the same engine.

Buick Cars &... | Answered on May 29, 2020


Check the transmission fluid level, it sounds like it is low and when it get warm it is high enough to work.

Buick Cars &... | Answered on May 25, 2020


n the picture, the belt tensioner is circled. Toward the bottom of tensioner, see the square cut out, have to use rachet drive--breakover or something in that cavity, pull tensioner cw to release tension on belt. Sometimes it is hard to pull. Depending on how long the handle on the tool, you may have to use cheater pipe on it? The cut-out maybe be 3/8 or 1/2 inch drive, not positive?

Buick Cars &... | Answered on May 25, 2020


have it checked for codes and test the fuel pressure

Buick Cars &... | Answered on May 24, 2020


Sure. Anything is possible with a rocker switch and wiring. You would need to secure the swich with an external clamp to the top of the column.

Buick Cars &... | Answered on May 22, 2020


Please follow this link to find the 2006 Buick Lacrosse's belt diagram: https://galvinconanstuart.blogspot.com/2019/04/2005-buick-lacrosse-belt-diagram.html

Buick LaCrosse... | Answered on May 21, 2020


Your Buick has a heater core o heat the air sent from the air conditioning unit before it is blown outwards. A malfunctioning heater core may cause the coolant to leak on the inside of the car, or It may even lead to smoke blowing out from the air vents.
Replacing the heater core will solve the problem, and to do so, you require a socket wrench and a Philips head screwdriver. Thi process is straight forward, but it may take up to an hour to finish
1. Pop open the hood, lift it, and then disconnect the bettery by using a socket wrench
2. On the passenger side, unwind the four screws from the kick panel which is underneath the glove box
3. Disconnect and remove the kick panel
4. Open the glove box, remove all contents within, and then unmounts the whole glove box by removing the screws
5. Pull down the flange, and you can access the heater core. To open it up - remove the two bolts from heater core cover and lift it off
6. Disconnect the core's wiring harness, then remove the four screws that are holding it in by using a Philips head screwdriver. Now you can easily remove the lousy heater core
7. Install the new heater core, then - reconnect wiring, screws, heater core case, and finally, the bolts
8. Reattach the kick panel and then glove box, and you are done

2006 Buick... | Answered on May 21, 2020


The oil light with wrench symbol means that your car needs an oil change and quickly. However, if you believe that's an error, use the Digital Instrument Cluster located on the dash to reset it or carry out the following steps to reset it:
1. Put the key into the ignition and switch to ON position
2. Once the dash lights have turn off - fully press the accelerator and release it three times in a row within five seconds
3. Now start the car and the error should have gone away

2007 Buick... | Answered on May 20, 2020


Please follow this link to find the 2007 Buick Lucerne serpentine belt diagram: https://serpentinebelthq.com/2006-2011-buick-lucerne-v6-3-8l-serpentine-belt-diagram/

2007 Buick... | Answered on May 20, 2020


Your Rendezvous has GM PasskeyIII

"When trying to start the vehicle if the engine does not
start and the SECURITY message comes on, the
key may have a damaged transponder. Turn the ignition off and try again."

So if the SECURITY is showing on message center then the key is not recognized and you will need to try a different transponder key.

If SECURITY is not showing, then set the emergency brake and move transmission selector to N(uetral), keep foot on brake and try to start.

Buick Cars &... | Answered on May 14, 2020


There is no reset switch, you likely have a bad fuel pump, try this use a 2x4 or soft hammer to rap on the fuel tank as someone turns the switch on and off when you hear the pump hum the car will start and run but change the pump immediately. Almost every other problem that occurs in the fuel system will cause the check engine light to come on and it will set a readable code. I hope this helps. Take care.

Buick Cars &... | Answered on May 12, 2020


Cooling System Capacity. Cooling System, 11.6 quarts, (10.9 L). Including Reservoir.

Buick Century 2000 oil, coolant, transmission fluids capacities ...

oemcats.com > wiki > buick > 2000 > century
When draining/replacing converter, more fluid will be needed. Cooling System Capacity. Cooling System, 11.6 quarts, (10.9 L). Including Reservoir. Fuel Tank ...

Buick Cars &... | Answered on May 12, 2020

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,702 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,571 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,065 Questions

2002 Buick Rendezvous
2002 Buick Rendezvous

1,065 Questions

1994 Buick LeSabre
1994 Buick LeSabre

891 Questions

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85239 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14832 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...