Refrigerators - Page 9 - Recent Questions, Troubleshooting & Support

0helpful

1answer

How many cubic feet is my Kenmore refrigerator model number 363.9601410

How do I find the cubic feet of my Kenmore refrigerator. ... the model breakdown for your model, 363.9601410, it is shown as a 20 cubic foot refrigerator.

Read full answer

11/28/2021 12:39:04 PM • Refrigerators • Answered on Nov 28, 2021

0helpful

1answer

Samsung fridge not cooling

21E or 21C. https://www.google.com/search?q=samsung+refrigerator+error+code+21c

21E

Freezer Fan Error This means the electronics are not sensing rotational feedback from the fan when it's supposed to be turning. This usually means the fan is frozen up, which can be caused by the door being left open or if there is a gap in the door gasket when it's supposed to be closed. It could also be fan motor failure. If you wish to defrost the unit, you can, otherwise visit our Support Center to request service. In addition to defrosting, make sure the unit is not packed so full that it prevents the doors from closing completely. Check that the door gaskets make a full contact connection all the way around the door. .

Read full answer

11/27/2021 7:33:29 PM • Samsung... • Answered on Nov 27, 2021

0helpful

2answers

Where is the temperature control located for kenmore coldspot refrigerator model 106.51139210

There are two temperature sensors (one in the refrigerator and one in the freezer). The refrigerator sensor is near the front of the compartment on the right side below the door switch and above the slides for the drawers. The freezer's refrigerator temperature sensor is on the left near the top of the compartment. See the two liner diagrams on the page linked below. To change the temperature, press and hold the Temperature button on the LCD panel for 3 seconds. The display should read the current temperature set point and Refrigerator. Use the Acceler-Ice button to lower the temperature in the fridge. Press the Lock button to raise the temperature in the refrigerator compartment. Press Temperature again to see the Freezer set-point and adjust it as above. Note: the temperature in each part of the unit depends on air circulating from the freezer into the refrigerator. Make sure that the vents aren't blocked. Wait 24 hours after adjusting the temperature set points for the unit to reach equilibrium before deciding if the set point should be adjusted further. Sears Parts Direct has the parts diagrams for the 106.51139210 here: https://www.searspartsdirect.com/model/4lfq9qfxpx-000582/kenmore-10651139210-side-by-side-refrigerator-parts . This page also has a link to the owner's manual for the side-by-side refrigerator, https://c.searspartsdirect.com/mmh/pd_download/lis_pdf/OWNM/1302214L.pdf . See page 15 of the manual for the information on setting the temperature set-points. I hope this helps. Cindy Wells

Read full answer

11/27/2021 7:33:25 PM • Kenmore... • Answered on Nov 27, 2021

0helpful

1answer

Norlake walk-in freezer ice built up ?

Susanewman you cannot get something for nothing!

Read full answer

11/24/2021 7:02:39 PM • Refrigerators • Answered on Nov 24, 2021

0helpful

1answer

Kitchenaid over and microwave does not ding at the end of a timer

The ding comes from a sounder that is soldered onto the main control board. It can be replaced at a Service Centre.

Read full answer

11/24/2021 6:55:56 PM • KitchenAid... • Answered on Nov 24, 2021

0helpful

1answer

I have a Marvel 6BAR6013 beverage cooler. The cooler seems to just run and never turn off. When I lower the temperature the unit does turn off but never back on.

I cannot locate any parts for that unit or even that model number but it appears from your description that the temperature sensor has issues. I am not able to tell if it is a themistor, bimetal spring or capillary tube type. Which ever type it is, it needs replaced.

Read full answer

11/24/2021 6:34:24 PM • Marvel... • Answered on Nov 24, 2021

0helpful

2answers

Flashing FO than 12 in display of Hitachi refrigerator R-S700 model. What's the problem?

FO 12 Error mean dose not freeze. maybe freezer broken. https://tehranservice.org/ http://aparatservice.com/

Read full answer

11/24/2021 6:34:17 PM • Refrigerators • Answered on Nov 24, 2021

0helpful

1answer

Magic Chef HMDR1000BE - Garage Heater Kit

I found this. It might be worth a try. https://www.applianceblog.com/mainforums/threads/garage-heater-kit.21876/ ..

Read full answer

11/24/2021 6:33:59 PM • Magic Chef... • Answered on Nov 24, 2021

0helpful

1answer

Our refrigerator door handle on our fisher & paykel broke off at the bottom. I have a new handle. What do I have to do to install it?

ask a dealer

Read full answer

11/24/2021 6:33:56 PM • Fisher... • Answered on Nov 24, 2021

0helpful

1answer

My Philco upright freezer stopped working and displayed E5 error code ?

In a Hotpoint it is Refrigerator Error Code E5 Freezer defrost sensor fault You could ask the maker direct http://philco-intl.com/ Apparently Philco is Electrolux https://finderrorcode.com/electrolux-refrigerator-error-codes.html E5 0 degree compartment sensor damaged ..

Read full answer

11/24/2021 6:33:49 PM • Refrigerators • Answered on Nov 24, 2021

0helpful

1answer

Fisher &Pakel Model E522B. How to replace the slide LH Assembly P/N 836703? I have the replacement part.

some videos that might help. It is tricky to get them latched. https://www.google.com/search?q=Fisher+Paykel+E522B.+replace+Rail+assembly+in+the+freezer ..

Read full answer

11/24/2021 6:33:43 PM • Fisher... • Answered on Nov 24, 2021

0helpful

1answer

Marvel ice maker has started making thin ice??

perhaps the filter needs changed

Read full answer

11/24/2021 6:33:38 PM • Marvel... • Answered on Nov 24, 2021

0helpful

1answer

Just bought a Telefunken TSB-70S bar fridge, when plugged in it goes on but it does not make cold

If it is brand new, contact the seller as it is under warranty. It should get cold within an hour or so.If it is new to you, you need a refrigeration engineer. It probably needs a gas top up or new thermostat / Thermister.

Read full answer

11/24/2021 6:33:22 PM • Refrigerators • Answered on Nov 24, 2021

0helpful

2answers

How to i clean food debris How do I remove debris that is stuck in the from section of the crisper drawers?

I contacted Samsung regarding this exact issue. Woe is me I cleaned my drawers and now have water in addition to food stuck in them. The solution is... Nothing. Yup, was told there is nothing you can do. There is no way to clean between those two pieces of factory connected pieces of plastic. We have to live with it. Guess what my next fridge will NOT be? Yeah...

Read full answer

11/24/2021 6:33:17 PM • Samsung... • Answered on Nov 24, 2021

0helpful

1answer

Admiral side by side fridge freezing food

Either a fan motor bad or you have it loaded wrong,too much food,Got to have room to move air or it will freeze.

Read full answer

11/24/2021 6:33:04 PM • Admiral... • Answered on Nov 24, 2021

0helpful

3answers

My door alarm on Kenwood fridge/freezer beeps when I close the door and freezer temp flashes -88 before going back

I have a Kenwood tall fridge (KTL60X15) which developed similar faults. It was beeping every time the door was opened (the display showed 88 and all other buttons were lit) and it would beep again when closed. Turns out the wiring from the fridge body to the door had worn out and by the time I discovered the problem 3 of the 5 wires had broken. The wiring can be round under the plastic covers at the top of the door and at the top of the fridge body.. I replace the wiring which was easy to do as it comes as a wiring harness kit (HK1495740) and adjusted how the wiring goes across the top hinge by making a small modification to the plastic covering on the top of the fridge body. So hopefully it won't wear out (at least now I can see it and keep an eye on it).