Refrigerators - Page 6 - Recent Questions, Troubleshooting & Support
No power to Amana ice and water dispenser. Rest of refer runs fine.
It's possible that the issue could be with a micro switch located on the ice maker cabinet that is activated when the prong on the back of the ice/auger tray is inserted. It's also possible that there could be another issue with the dispenser, such as a problem with the wiring or a malfunctioning component. I would recommend checking the wiring and testing any other micro switches or components that are related to the dispenser to see if they are functioning properly. If you are unsure how to do this, I would recommend consulting the user manual or contacting a qualified technician for further assistance.
1/14/2023 10:27:43 AM •
Amana...
•
Answered
on Jan 14, 2023
How do I remove temp control panel on a GE GDS18SBP
You must carry out the following procedures in order to remove the temperature control panel from a GE GDS18SBP refrigerator:
Find the refrigerator's temperature control panel. Usually, it is near the top of the interior of the refrigerator compartment.
The clips or screws holding the control panel in place should be removed. The back of the control panel is normally where these screws or clips are positioned.
Carefully pull the control panel away from the refrigerator, being careful not to damage any wires or connectors.
Once the control panel is removed, you should be able to access the defrost timer. The defrost timer is a small device that controls the defrost cycle of the refrigerator. It is typically located near the compressor or the evaporator coils.
To change the defrost timer, you will need to remove the screws or clips that hold it in place, and then carefully disconnect any wires or connectors.
Replace the old defrost timer with a new one, making sure to connect any wires or connectors correctly.
Reinstall the control panel, making sure to secure it in place with the screws or clips.
Once the control panel is reinstalled, turn the refrigerator back on and test the temperature control to make sure it is working properly.
Kenmore Refrigerator 795.75052 Gear Support Assembly (how to attach)
You may have a problem with the gear assembly for the freezer tray on your Kenmore Elite refrigerator. The gear assembly is responsible for supporting the rear of the basket and keeping it in place.
Your description sounds like your gear assembly may be an older generation and may not have screw holes for attaching the gears to the support arm sliders. The gears may be designed to be snapped into place on the support arm sliders.
The plastic tab you mentioned at the back of the slider is likely the attachment point for the swivel hub on the gear. To attach the gears, align the swivel hub with the plastic tab, then gently push it in until it snaps into place.
The tab may be jammed or stuck; in that case, you can gently pry it loose with a small flat-head screwdriver.
If you continue to have trouble installing the gear assembly, consider contacting Kenmore's customer service for further assistance. They can provide you with a detailed exploded parts diagram or even a video tutorial on installing the gear assembly properly
1/14/2023 9:17:51 AM •
Kenmore...
•
Answered
on Jan 14, 2023
I have a GE ENERGY STAR 24.7 Cu. Ft. French-Door Refrigerator Model #: GNE25JGKBB. Sabbath mode does not turn on.
There could be a few reasons why your GE ENERGY STAR 24.7 Cu. Ft. French-Door Refrigerator, Model #: GNE25JGKBB, won't go into Sabbath mode.
You can try a few of the following:
Control lock inspection
Check to see if the control lock is off.
You won't be able to switch on the Sabbath mode if the control lock is activated.
Verify the water filter's condition:
Verify that the water filter is clear and out of date.
The operation of the Sabbath mode may be hampered if the water filter is blocked or past its expiration date.
Verify the control settings:
Make sure the appropriate control type is installed in your refrigerator.
You should adhere to these directions for models with Figure B controls.
Look in the manual:
Verify that you are correctly adhering to the directions.
Refer to the manual once again for additional thorough instructions if you need clarification on any steps or have any other concerns.
Contact GE for more help if you've tried all the above suggestions but still have trouble turning on the Sabbath mode.
They may need to send a professional to fix or replace the refrigerator, or they may be able to offer you further troubleshooting tips or steps.
It's important to note that some models do not have sabbath modes without icemakers; if this is the case for your model, the sabbath mode option is unavailable.
Samsung refrigerator is leaking from water tank
It sounds like there may be multiple issues with your Samsung refrigerator. Here are a few steps you can try to troubleshoot the problem:
- Check the water valve: Make sure that the water valve is open and functioning properly.
- Check the water line: Make sure that the water line is not kinked or damaged.
- Check the water filter: Make sure that the water filter is properly installed and not clogged. If you are having trouble with the filter not screwing in properly, you may want to try a different brand of filter.
- Check the defrost drain: Make sure that the defrost drain is not clogged or blocked, and that the drain tube is not obstructed by rust.
- Check the water tank: Make sure that the water tank is not damaged and that it is properly sealed.
- Check the grommet: Make sure that the grommet is not cracked or damaged.
- Consult the manual: Consult the manual for specific troubleshoot and service information for your Samsung RF26VABPN refrigerator model.
It's important to note that these steps are general guidance and the specific steps may vary depending on the model of your Samsung refrigerator. Make sure to consult the manual for the specific steps and precautions before performing any maintenance or repairs on your refrigerator. If the problem persists, it is best to contact Samsung customer service or a professional for further assistance and repair options.
1/14/2023 1:17:24 AM •
Samsung...
•
Answered
on Jan 14, 2023
Noise at the top, constant
Are you saying you get the noise even when the refrigerator is not cooling? If you get the noise only when the refrigerator "runs", it is the fan as you suggest.
1/12/2023 4:08:13 AM •
Viking...
•
Answered
on Jan 12, 2023
Door Handle - Screw coming out
Not quite sure about your problem but, if it is a wood screw going into your door, you can take the screw out a insert a hardwood toothpick into the screw hole and reinstall the screw. this will fill any stripped out of the hole and screw should fit securely. If it is a metal to metal problem you can go to the hardware store or even walmart and buy a product called " Locktight". it is a liquid that you put on the screw and reinstall it. it will dry and lock the screw in place. Buy the blue if you want to eventually take it out at some point or buy the red, if you want it to stay in place and take a lot of effort to get it back out.
1/12/2023 1:14:50 AM •
Maytag...
•
Answered
on Jan 12, 2023
Sounds like heavy breathing
The # 5 thermistor , pt # WR55X10025, located at the bottom of the freezer , slightly in front of the drain , with 2 white wires going to it , slid into a housing . This thermistor , is the freezer thermistor , which tells the control board , the freezer temp , when to cycle off , and is associated with the fan speed . The " breathing " sounds like the fan speeding up and slowing down . Replaceing this thermistor , should fix the problem .
The desert
The animals live in the desert who take less water. For sharing sometime with the animals and enjoy animal safaris there. Get details here https://www.orient-tours-uae.com
Samsung SRS702GDHSS refrigerator press the control panel button not working
There could be a few reasons why the control panel buttons on your Samsung refrigerator are not working. Here are a few things you can try to fix the issue:
- Make sure the fridge is plugged in and the outlet is functioning properly.
- Check if the fridge is in Demo Mode. This is a feature that disables the control panel buttons when the fridge is in a store or showroom. To exit Demo Mode, press and hold the "Power Cool" and "Power Freeze" buttons for 8-10 seconds.
- Check if the control panel lock feature is activated. This feature prevents the buttons from being pressed accidentally. To deactivate the lock feature, press and hold the "Lighting" and "Fridge" buttons for 8-10 seconds.
- If none of these solutions work, there could be an issue with the control panel itself. In this case, it is recommended to contact Samsung customer support or a qualified appliance repair technician for further assistance.
1/8/2023 4:42:43 AM •
Samsung...
•
Answered
on Jan 08, 2023
Not finding what you are looking for?