Heavy Machinery - Page 5 - Recent Questions, Troubleshooting & Support

?? ?????????? ??????? ?????????? ????? ?? ????

have you inspected -tried adjusting clutch -or need a clutch

damaged gearing -damaged linkage - debris --

try GOOGLE

Sensor out of position.....sensor circuit problem ....sensor failure

code-64-03 means shut down of power relay, GOD-BLESS!

probably broke a shear pin

https://interglobealliance.com/blogs/tutorials/how-to-clear-forklift-error-code-hyster-and-yale-2005-and-newer-models

I think that the start run capacitor needs replacing there are no oiling points

Have you changed fuel filter recently?

You've found the right place buddy I keep buying manuals from various websites so I can damn well help u in this.. what chipper is it btw? Like few websites have some manuals better while some have other brands better

Remove the 5/16" allen cap screw on the end of the shaft. The knife assembly slides onto the crankshaft and is keyed with a woodruff key. Soak the shaft in pentrating oil overnight and try to slide it off or use more persuasive measures like tapping or a slide hammer. You'll see a big nut it's a LH thread so to remove it turn it CCW. The rest is straight forward. I can send you the owners manual if you provide an email address. It illustrates the process in detail. Ronald

Reply

hello u will find a lot of wiring diagram s and circuit diagrams and stuff like this at few sites I know the girl in the chat box can help u instantly

Request the diagram directly from Troy-Bilt.

Contact the manufacturer/distributor to order it.

Contact the manufacturer/distributor to request the manual.

Wrap belt in foil put in 375 oven for 45-60 minutes and it should go on with screw driver as wedge. Use gloves and work fast so as not to let cool off. After install let cool before using.

It is low on gear oil. When it gets hot it freezes up. Add gear oil.

Yes I have one in perfect condition with prints etc. and the original sale brochure!