Grilling - Page 5 - Recent Questions, Troubleshooting & Support


Many temp guides available on the internet. It depends on how you like your meat cooked. 145 for beef 165 for pork.

Grilling | Answered on Aug 18, 2019


Check the small cal rod in the pot. May also be the thermocouple is open and telling the controller not to heat up the pot.

Grilling | Answered on Aug 18, 2019


The more you load up your Traeger the longer it takes due to the mass of so much meat to come up to temp.

Grilling | Answered on Aug 18, 2019


Probably the thermocouple not feeding back a signal(voltage) to the controller.

Grilling | Answered on Aug 18, 2019


Probably the overheat thermal switch is bad. Everything works until it doesn't!

Grilling | Answered on Aug 18, 2019


Replace the piezo electric starter.(push button starter)

Grilling | Answered on Aug 18, 2019


It was probably over filled. That is the relief valve letting off excess pressure, remove it from camper and leave it outside in a well ventilated area for awhile until the pressure equalizes.

Grilling | Answered on Aug 18, 2019


Masterbuilt Digital Smoker no longer heats up and digital display has stopped working completely. The unit acts like there is no power to it and is completely dead. By replacing the digital component will this solve my problem

Masterbuilt... | Answered on Aug 18, 2019


I have a Traeger, not a Pit Boss, but assuming they work on the same theory, you generally want to smoke at 225-250. The "smoke" setting is usually much lower than that (for smoking cheeses and such). Once you set your temp, your auger will feed pellets into your fire box on a timed cycle determined by your heat setting or thermostat. So you'll actually only see smoke every once in awhile.

Grilling | Answered on Aug 17, 2019


Not unusual in my limited experience, we have had two cookers where the ignition system would only light cold burners and would never light all the burners - once the majority was lit there was always a couple that wouldn't light though not always the same two.
We never did find the cause...

GE Grilling | Answered on Aug 16, 2019


Contact Home Depot for assistance.

FIXYA is a question and answer repair oriented internet site only, and does not sell equipment.

Kingsford... | Answered on Aug 14, 2019


How to Reset the Propane Regulator for a Gas Grill
  1. Open the cover lid on your gas barbecue and turn all burner dials to the OFF position. ...
  2. Disconnect the regulator from the propane tank shutoff valve by twisting the knurled mounting knob in a counterclockwise direction. ...
  3. Open the burner control knobs on the grill fully.
More items...

Dec 22, 2017

How to Reset the Propane Regulator for a Gas Grill ' Hunker


https://www.hunker.com/13408162/how-to-reset-the-propane-regulator-for-a-gas-grill

Make sure you open the valve very slowly the first time.

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&ei=frtJXYTdF7CKgge2-pvQCg&q=bbq+regulator+reset&oq=bbq+regulator

Weber Grilling | Answered on Aug 06, 2019


You can't, Weber don't allow it.

https://www.weber.com/CA/en/blog/burning-questions/can-i-convert-my-gas-grill/weber-29870.html

CAN I CONVERT MY GRILL FROM LIQUID PROPANE (LP) TO NATURAL GAS (NG), OR VICE VERSA? Due to safety considerations, the complexity of the components involved, as well as the level of disassembly required, wedon't allow conversions or provide conversion kits. Converting a Weber grill will actually void the warranty on the unit and might create an unsafe situation.
We do sell most of our gas grill models in both a propane version and a natural gas version, so if you're planning on purchasing a new grill, please make sure that you're selecting the appropriate model for the fuel type you plan on using.
We are very sorry for any disappointment this may cause, but the safety of our fans always comes first. You can read more about this in our blog on the subject here.

Grilling | Answered on Aug 06, 2019


Fixya is unable to suggest sources for Masterbuilt parts.

Masterbuilt... | Answered on Jul 28, 2019


Still under warranty, claim for a new element. If the element has gone, the light is in the same circuit.

Grilling | Answered on Jul 22, 2019


It is drawing too many amps for the circuit.

Grilling | Answered on Jul 22, 2019

Not finding what you are looking for?
Grilling Logo

10,604 questions posted

Ask a Question

Usually answered in minutes!

Top Grilling Experts

Paul Carew

Level 3 Expert

3510 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Tom Chichester

Level 3 Expert

55379 Answers

Are you a Grilling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...